Chicago Pneumatic
Chicago Pneumatic CP7500D Angle Grinder 2 in 0.2 hp 22000 RPM
Compact 2 in angle grinder with 0.2 hp motor and 22000 RPM for medium-duty tasks
- TypeAlignment Tools
- Compact reach fits tight workspaces
- 2 hp motor delivers consistent medium-duty power
- Variable speed control matches grinding tasks
- Safety lever prevents accidental start-up
- 22000 RPM max speed removes material quickly
Compact Angle Grinder for Medium Duty Tasks
The Chicago Pneumatic CP7500D is a 2 in angle grinder rated at 0.2 hp and a maximum speed of 22,000 RPM. It is built for medium duty grinding and cutting work where a compact reach is needed. The safety lever and variable speed control give the operator direct handling control during use.
Pneumatic Integration and Workspace Access
This tool connects via a 1/4 in NPT female air inlet and accepts Type 27 wheels on a 3/8 in.-24 spindle thread. Its compact reach lets it access tight work areas that larger grinders cannot fit. The pneumatic drive removes the need for an electric motor or power cord at the point of work.
Air Consumption and Operational Heat
Normal use draws compressed air through the 1/4 in inlet at pressures the shop supply regulates. The aluminium housing conducts operational heat away from the internal vane motor during extended runs. Noise output is typical for a 22,000 RPM pneumatic tool under load.
Highlights
- Compact reach fits tight workspaces
- 2 hp motor delivers consistent medium-duty power
- Variable speed control matches grinding tasks
- Safety lever prevents accidental start-up
- 22000 RPM max speed removes material quickly
Specifications
| Brand | Chicago Pneumatic |
|---|---|
| Type | Alignment Tools |
Questions about this item
What spindle thread limits which wheels can be used on the CP7500D?
The spindle uses a 3/8 in.-24 thread so only wheels with that thread pattern will mount.
How loud and hot does the grinder get during a full shift of grinding?
The tool runs at 22 000 RPM with a 0.2 hp motor, so expect typical pneumatic whine and warm housing after continuous use.
What air supply fittings must already be on the shop hose for this grinder to connect?
It requires a 1/4 in NPT female air inlet, so your hose needs a matching 1/4 in NPT male fitting.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
