Chicago-Latrobe
Chicago-Latrobe 78591 7/64 in 140 Degree Carbide Straight Flute Drill
A 7/64 inch solid carbide straight flute drill bit with a 140 degree point angle and 13/16 inch flute length for precision machining
- TypeCutting Tools
- 7/64 inch fractional size matches precise hole requirements
- 140-degree point angle reduces walking on hard materials
- Solid carbide construction resists wear in abrasive applications
- 13/16 inch flute length clears chips from deep holes
- Bright uncoated finish suits general-purpose machining tasks
Chicago-Latrobe 78591 Carbide Drill
This 7/64 inch solid carbide straight flute drill is built for precision hole-making in abrasive or hardened materials where high-speed steel wears too quickly. It suits machinists and maintenance technicians who need consistent hole size and finish without frequent resharpening. The bright uncoated surface and 140 degree point angle support accurate starting in a range of ferrous and non-ferrous alloys.
Sustained cutting behaviour
Carbide holds its edge far longer than steel under continuous feed, so the drill maintains diameter and surface quality through long production runs without the deflection that leads to oversize holes. The four-facet point reduces thrust force, lowering heat buildup at the tip and helping the tool stay on centre during deep passes. Bright finish chips evacuate cleanly through the straight flutes when coolant or air blast is used.
Installation and common issues
The straight shank fits standard drill chucks and collets without adapters; secure it firmly to prevent slippage under the high torque carbide can generate. Run at the correct surface speed for the workpiece material — excessive RPM causes chipping, while too slow a feed work-hardens the hole wall. Avoid hand-held use; the brittle carbide snaps if the drill walks or the workpiece shifts. Buyers who need a coated tool for stainless steel or a split-point geometry for self-centring without a pilot should select a different drill.
Highlights
- 7/64 inch fractional size matches precise hole requirements
- 140-degree point angle reduces walking on hard materials
- Solid carbide construction resists wear in abrasive applications
- 13/16 inch flute length clears chips from deep holes
- Bright uncoated finish suits general-purpose machining tasks
Specifications
| Brand | CHICAGO-LATROBE |
|---|---|
| Type | Cutting Tools |
Questions about this item
Will the 140-degree carbide tip run hot when drilling continuously?
The 140-degree point angle on solid carbide reduces thrust and heat buildup during extended drilling sessions.
What shank size must my drill chuck accept for the 7/64 inch bit?
The fractional 7/64 inch shank fits any standard chuck that holds up to .109375 inch diameter.
Can the 13/16 inch flute length reach through a 1/2 inch workpiece on my older press?
Yes, the 13/16 inch flute provides ample clearance for a 1/2 inch thick workpiece on any drill press.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
