Cherne
Cherne 270261 Mechanical Pipe Plug Trap 6 In
Mechanical pipe plug seals 6 in pipes with 5.77–6.08 in range, rated for 17 PSI air or 40 ft head pressure
- TypeDrain Components
- MaterialHAWA
- Seals pipe ends securely with 6-inch mechanical plug
- Fits pipes from 5.77 to 6.08 inches diameter range
- Withstands 17 PSI air pressure for leak testing
- Handles 40 feet of head pressure during installation
- Durable ABS plastic and rubber construction resists corrosion
Mechanical Pipe Plug Application
The Cherne 270261 is a mechanical pipe plug designed to seal the end of a pipe. It fits nominal 6 inch pipes with an internal diameter between 5.77 and 6.08 inches. Construction uses rubber and ABS plastic for durability. The plug installs without adhesives or special tools.
Suitable Uses And Limitations
This plug suits maintenance crews and contractors needing a temporary or reusable seal for 6 inch lines. It handles back pressure up to 17 PSI or 40 feet of head. It is not for buyers needing a permanent glued closure or a plug for smaller or larger diameter pipes.
Critical Sizing Specification
The nominal 6 inch size covers a specific diameter range of 5.77 to 6.08 inches. Verifying the pipe internal diameter falls within this window is the single specification that determines whether this plug will seal correctly.
Highlights
- Seals pipe ends securely with 6-inch mechanical plug
- Fits pipes from 5.77 to 6.08 inches diameter range
- Withstands 17 PSI air pressure for leak testing
- Handles 40 feet of head pressure during installation
- Durable ABS plastic and rubber construction resists corrosion
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Brand | Cherne Industries |
| Model | 270261 |
Questions about this item
How do I install the Cherne 270261 mechanical plug and what step is often missed?
Insert the plug into the pipe end, then tighten the mechanical mechanism until the rubber seals against the pipe wall. The step often missed is confirming the pipe inside diameter falls between 5.77 In and 6.08 In before installation.
What maintenance or replacement will the Cherne 270261 plug need later?
Inspect the rubber sealing element and ABS plastic body for cracks, hardening or deformation before each use. Replace the plug if the rubber no longer forms a tight seal or if the mechanical tightening parts show wear.
What limit appears first during sustained pressure testing with the Cherne 270261 plug?
The 17 PSI maximum back air pressure rating is typically reached before the 40 Ft of head water pressure limit during sustained air testing. Do not exceed either rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
