Centenex Electronics
Centenex Electronics DS-CS-SRH200SL Battery for Sony SP73 1050mAh
Replacement lithium-ion battery delivering 1050 mAh at 3.7 V for compatible Sony headphones
- TypeBluetooth Headset
- Compatible with Sony MDR-1000X, MDR-1ABT, SRS-BTS50, WH-1000XM2
- 1050 mAh lithium-ion cell restores original run time
- Replaces Sony part numbers SP73, SP-73, 4-296-914-01
- Compact 44.73 × 37.40 × 6.85 mm profile fits factory battery bay
- Brand-new, 100 % OEM-compatible unit ready to install
Purpose-built replacement
This Centenex Electronics DS-CS-SRH200SL cell replaces the Sony SP73 pack inside MDR-1000X, MDR-1ABT, SRS-BTS50 and WH-1000XM2 headphones. It is a 3.7 V, 1050 mAh lithium-ion unit measuring 44.73 x 37.40 x 6.85 mm and finished in black. Buyers who need a higher-capacity cell or a different form factor cannot use this battery.
Sustained discharge
The 3.89 Wh rating supports typical wireless-listening sessions without the voltage sag seen in aged original packs. Internal resistance stays low over repeated charge cycles, so playback time remains consistent. The pack is not designed for high-drain applications beyond headphone use.
Drop-in installation
The battery ships new and matches the SP73 footprint, so no soldering or case modification is required. The only common issue is forgetting to reconnect the flex cable before sealing the earcup, which leaves the headset dead on first power-up.
Highlights
- Compatible with Sony MDR-1000X, MDR-1ABT, SRS-BTS50, WH-1000XM2
- 1050 mAh lithium-ion cell restores original run time
- Replaces Sony part numbers SP73, SP-73, 4-296-914-01
- Compact 44.73 × 37.40 × 6.85 mm profile fits factory battery bay
- Brand-new, 100 % OEM-compatible unit ready to install
Specifications
| Brand | Centenex Electronics |
|---|---|
| Model | DS-CS-SRH200SL |
| Type | Bluetooth Headset |
Questions about this item
How much heat does the 3.7 V 1050 mAh cell produce during a full day of playback?
The lithium-ion pack is rated at 3.89 Wh; normal operation stays warm to the touch but does not become hot under typical listening volumes.
Which tools or adhesive strips are required to swap the battery inside my MDR-1000X?
A small Phillips screwdriver, a plastic opening tool and the pre-cut adhesive strips included with the replacement cell are all that is needed.
Will the 44.73 mm × 37.40 mm × 6.85 mm pack fit the older MDR-1ABT without modifying the housing?
Yes, the dimensions match the original SP73 cell used in the MDR-1ABT, so the battery compartment closes normally.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Sony ZX Series MDR-ZX110AP Wired On-Ear Headphones White 30mm 3.5mm
- Headphone
usbroway 10-pack VHF Antenna 136-174MHz for Motorola HT1000 MTS2000 XTS2500 XTS3000 XTS3500
- Two-way Radio



