We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Canon REALiS WUX6010 projector lamp module with 340W Ushio NSH bulb in housing

Canon

Canon REALiS WUX6010 OEM Replacement Projector Lamp 340W

SKU CH-90KC-011KJ

Genuine 340W Ushio NSH bulb in a pre-assembled housing delivers 2000 to 4000 hours of projection for the REALiS WUX6010

  • TypeNSH
  • Wattage340W
  • Lamp Life2000 - 4000 hours
  • Ready to install with bulb and housing assembled
  • 340 watt NSH lamp powers bright projection
  • Lamp life rated 2000 to 4000 hours
  • OEM replacement built to ISO 9001 quality standards
  • Tested for beam performance ignition voltage and run time

Canon REALiS WUX6010 Lamp Module

This replacement lamp module is built for Canon REALiS WUX6010 projectors and ships as a complete housing with a new 340W NSH bulb installed. It is intended for venues, classrooms or home cinema setups that need a direct, ready-to-fit light source without separate bulb handling.

Build and Daily Use

The unit arrives fully assembled so installation is a single step; no alignment of a bare burner is required. Each module is produced to ISO9001 quality checks covering beam performance, ignition, voltage, connections and run-time, and the housing fits the projector's existing mount points exactly.

Check Before Ordering

Verify that your projector is the REALiS WUX6010 model and that the existing lamp uses a 340W NSH burner rated for 2000 to 4000 hours of service life. This module replaces the Canon RS-LP09 part number only; other REALiS models or third-party housings will not match the electrical or mechanical interface.

Highlights

  • Ready to install with bulb and housing assembled
  • 340 watt NSH lamp powers bright projection
  • Lamp life rated 2000 to 4000 hours
  • OEM replacement built to ISO 9001 quality standards
  • Tested for beam performance ignition voltage and run time

Specifications

BrandCanon
TypeNSH
Wattage340W
Lamp Life2000 - 4000 hours

Questions about this item

Does the RS-LP09 lamp module use the 340 W NSH bulb for the REALiS WUX6010?

Yes, the RS-LP09 module ships with a new Ushio NSH 340 W bulb already installed in its housing, so the projector receives the specified 340 W output without any extra assembly.

Will the RS-LP09 housing align with the REALiS WUX6010 lamp cage and connector?

The module is built to the original Canon RS-LP09 dimensions, so the housing slides into the WUX6010 lamp cage and the connector seats directly without adapters or modifications.

What is the correct sequence to install the RS-LP09, and where do installers commonly err?

Power off and cool the projector, remove the lamp cover, release the retaining screws, pull the old module straight out, insert the new RS-LP09 until the connector clicks, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — skipping the timer reset is the most frequent mistake.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.