Cameron Sino Battery for Palm Tungsten E UP383562A A6 900mAh
Replacement battery compatible with Palm Tungsten E, 900mAh capacity, 55g weight
- Weight55g
- Replacement battery for Palm Tungsten E
- 900 mAh capacity powers your device
- 55 g lightweight design adds minimal bulk
- Certified to ISO 9001 RoHS and CE standards
- Rechargeable lithium-ion chemistry for repeated use
Direct replacement for Palm Tungsten E
The Cameron Sino battery fits the Palm Tungsten E and matches the original UP383562A A6 part number. It delivers a rated capacity of 900mAh in a new, rechargeable cell weighing 55g. Buyers needing a higher-capacity pack or a different form factor should look elsewhere.
Steady output for daily PDA use
The 900mAh lithium-ion cell maintains consistent voltage through a full day of organiser tasks without the sharp drop-off seen in aged originals. Built-in protection guards against over-charge, over-discharge and short circuits. Users who demand extended runtime beyond a single charge cycle will find the capacity limiting.
Simple drop-in installation
The pack slides into the Tungsten E battery compartment and the connector aligns with the original socket; no tools or soldering are required. Most issues arise when the connector is not fully seated or when a low-quality charger is used, which can prevent the pack from reaching full performance after the first few cycles.
Highlights
- Replacement battery for Palm Tungsten E
- 900 mAh capacity powers your device
- 55 g lightweight design adds minimal bulk
- Certified to ISO 9001 RoHS and CE standards
- Rechargeable lithium-ion chemistry for repeated use
Specifications
| Brand | cameron sino |
|---|---|
| Model | Bissell ICONpet Cordless 2288 |
| Part Number | Palm UP383562A A6 |
| Weight | 55g |
Questions about this item
Does the 900mAh battery run hot when the Palm Tungsten E is left on all day?
The 55g cell is rated at 900mAh and contains a protection circuit against overcharge and over-discharge; normal PDA use does not produce noticeable heat.
What must I already own to install this UP383562A A6 pack?
You need a Palm Tungsten E with the original battery connector accessible and a standard Palm sync cradle or charger for the first charge cycles.
Will this replacement work alongside my original Palm charger and cradle?
Yes, the fully decoded chip matches the original FNB-10 series specifications, so the existing charger and cradle operate exactly as before.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Shenzhen LVSUN Electronics Co. Ltd G20-MBAT cell phone battery 1600mAh 3.7V
LG Electronics BL-53QH 2100 mAh cell phone battery (2 pack)
- Replacement Battery
- LG



