Cameron Sino Battery for Mosquito Magnet Independence 3000mAh 14.4Wh
Nickel-zinc replacement battery for Mosquito Magnet Independence models, 3000 mAh capacity with built-in protection circuits
- Typenickel_zinc
- Capacity (mAh)3000mAh / 14.4Wh
- Compatible with Mosquito Magnet Independence
- 3000mAh capacity powers extended operation
- Nickel-zinc chemistry at 4.8V voltage
- Compact 44.10 x 44.80 x 44.80mm dimensions
- Built-in protection against overcharge and short circuit
Replacement Battery for Mosquito Magnet Independence
This Cameron Sino battery replaces the original pack in Mosquito Magnet Independence units. It uses nickel-zinc chemistry and delivers a nominal 4.8 volts with a 3000mAh capacity. The pack fits models carrying part numbers 565-035 and 9994141. It arrives new with a decoded chip that communicates with the device.
3000mAh Capacity and Runtime Headroom
The 3000mAh rating provides the same energy reserve as the factory cell for standard trap operation. It powers the unit through typical overnight cycles without voltage sag. Runtime will fall short if the trap runs continuously in high-insect areas or if the fan motor draws above-spec current. The 14.4Wh figure confirms the total energy available per charge.
Thermals Noise and Power Draw
Nickel-zinc cells run cool during normal charge and discharge, so the pack adds no noticeable heat to the trap housing. No fan or moving parts exist in the battery itself, meaning operation is silent. The 4.8-volt output matches the original specification, so the trap's electronics draw their usual current without extra stress on the protection circuit.
Highlights
- Compatible with Mosquito Magnet Independence
- 3000mAh capacity powers extended operation
- Nickel-zinc chemistry at 4.8V voltage
- Compact 44.10 x 44.80 x 44.80mm dimensions
- Built-in protection against overcharge and short circuit
Specifications
| Brand | Cameron Sino |
|---|---|
| Model | Independence, MM3200 |
| Type | nickel_zinc |
| Capacity (mAh) | 3000mAh / 14.4Wh |
Questions about this item
Will this 4.8 V 3000 mAh nickel-zinc pack fit my existing Mosquito Magnet Independence unit that uses part number 565-035?
Yes, it is built to the same 44.10 × 44.80 × 44.80 mm dimensions and decoded chip specification as the original 565-035 battery for Independence models.
How can I confirm the replacement battery is functioning correctly after I install it?
After fitting, run two or three full charge and discharge cycles; the pack should then deliver its rated 14.4 Wh capacity and hold voltage at 4.8 V under load.
Does the package include a charger or only the battery itself?
Only the single 226.0 g nickel-zinc battery with protective foam is supplied; a compatible charger must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



