We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular black lithium-ion battery pack, 73.40 by 41.74 by 21.30 mm

Cameron & Co

Cameron & Co YP-3 3.7V 6800mAh Li-ion battery

SKU CH-DJCN-61W9B

Replacement lithium-ion power pack for Yuneec Q500 and ST10 series controllers, rated 3.7 V 6800 mAh

  • TypePower Packs
  • Compatible with YUNEEC Q500 and ST10 series
  • 7 V 6800 mAh lithium-ion power pack
  • 16 Wh capacity for extended flight time
  • Compact 73.40 x 41.74 x 21.30 mm form factor
  • Brand-new Cameron Sino cell with 100 % OEM fit

Cameron & Co YP-3 Li-ion Power Pack

The Cameron & Co YP-3 is a 3.7V 6800mAh lithium-ion battery built for YUNEEC Q500, ST10, ST10 Chroma Ground Station and ST10+ Chroma Ground Station hardware. It supplies 25.16Wh of energy in a black casing that matches the original equipment form factor. Pilots needing a direct replacement for the YP-3 Blade part number will find this pack fits the same battery bay without modification.

Voltage and Capacity Limits

The pack delivers a nominal 3.7 volts and a rated 6.8 Ah capacity, which fixes the total energy at 25.16Wh for any flight or ground-station session. Runtime scales linearly with the current draw of the connected device, so higher throttle or brighter screens reduce usable minutes proportionally. No internal circuitry raises the voltage above 3.7V, and the chemistry does not support series or parallel linking without external management. Users must plan missions around this single-pack energy ceiling.

Installation Notes

The battery slides into the OEM compartment of each listed YUNEEC model and locks with the original latch mechanism. Polarity is keyed to the factory connector, so reverse insertion is physically blocked. The most common issue is a loose fit caused by worn latch tabs on older airframes, which can interrupt power under vibration. A second frequent problem is connector oxidation after long storage; a light contact clean restores reliable contact. No soldering or firmware updates are required.

Highlights

  • Compatible with YUNEEC Q500 and ST10 series
  • 7 V 6800 mAh lithium-ion power pack
  • 16 Wh capacity for extended flight time
  • Compact 73.40 x 41.74 x 21.30 mm form factor
  • Brand-new Cameron Sino cell with 100 % OEM fit

Specifications

BrandCameron Sino
TypePower Packs

Questions about this item

Should I choose the 3.7V 6800mAh version or the 25.16Wh rating for my YUNEEC ground station?

They describe the same cell — 3.7 volts multiplied by 6.8 amp-hours equals 25.16 watt-hours, so pick whichever label matches your manual.

What does the 6800mAh capacity mean for actual flight time on a Q500?

It stores 6.8 amp-hours at 3.7 volts, giving roughly 25 watt-hours of energy; real flight minutes depend on the drone’s power draw and conditions.

Does the pack use a standard JST or XT connector that fits the ST10+?

The unit is built as a direct replacement for the YP-3 blade pack used in the Q500, ST10, ST10+ and Chroma Ground Station.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.