Cameron & Co standard battery NTA552331 3.80V 380mAh 1.44Wh

Replacement Battery for Rode Wireless Go II

This lithium-polymer cell is built to fit the Rode Wireless Go II transmitter and receiver units. It supplies 3.80V and 380mAh for 1.44Wh of capacity, matching the original 0442-0053-01 specification. The pack targets content creators and field recordists who need a dependable spare or replacement power source.

Simple Snap-In Installation

The compact form factor slides into the Wireless Go II battery compartment without tools or soldering. Alignment tabs on the pack prevent reverse insertion, so the only common issue is forgetting to seat the connector fully before closing the door. No firmware pairing or calibration steps are required after the swap.

Steady Output During Long Sessions

Under continuous transmit load the cell maintains its nominal voltage without the sharp sag seen in aged packs, keeping the wireless link stable for full recording days. The Li-Polymer chemistry resists capacity loss over repeated charge cycles, so runtime remains predictable across months of daily use. Heat buildup stays low enough that the unit’s thermal throttle point is rarely reached.