We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular black lithium-ion GPS battery, 70.8 by 38.5 by 21 mm

Cameron & Co

Cameron & Co GPS Battery 7.4V 2200mAh Li-ion Black

SKU CH-RQFF-EB0Q2

Replacement lithium-ion battery delivers 7.4 V and 2200 mAh for JDSU NT-series test and validator units

  • TypeGPS Batteries
  • Reliable power for JDSU validators with 7.4 V 2200 mAh capacity
  • Li-ion chemistry delivers 16.28 Wh in a compact 70.80 x 38.50 x 21.00 mm case
  • Direct replacement for OEM part numbers 19-3762 NT93 NT99
  • Fits NT1150 NT1155 NT900 NT905 NT950 NT955 and Test-Um models
  • Brand-new Cameron Sino cell ensures 100 % OEM compatibility

Replacement Battery for JDSU Validators

This lithium-ion pack replaces the original power source in JDSU NT1150, NT1155, NT900, NT905, NT950 and NT955 validator units. It also fits Test-Um NT900, Test-Um NT99 and Validator-NT models. The cell delivers 7.4V and 2200mAh capacity in a black housing. OEM compatibility is rated at 100% for the listed part numbers.

Thermals Noise and Power Draw

The battery uses standard Li-ion chemistry with no active cooling components. Normal operation produces no audible noise and negligible heat under typical validator workloads. Power delivery follows the 16.28Wh rating across the supported voltage range. No additional thermal management is required for installation.

Upgrade From Older JDSU Packs

This unit replaces legacy batteries identified by part numbers 19-3762, NT93 and NT99. The jump is worthwhile when the original cell no longer holds sufficient charge for field operations. Capacity of 2.2Ah restores full runtime to compatible validator devices. Builders needing a different voltage or form factor should look elsewhere.

Highlights

  • Reliable power for JDSU validators with 7.4 V 2200 mAh capacity
  • Li-ion chemistry delivers 16.28 Wh in a compact 70.80 x 38.50 x 21.00 mm case
  • Direct replacement for OEM part numbers 19-3762 NT93 NT99
  • Fits NT1150 NT1155 NT900 NT905 NT950 NT955 and Test-Um models
  • Brand-new Cameron Sino cell ensures 100 % OEM compatibility

Specifications

BrandCameron Sino
ModelDS-CS-JDT905SL
TypeGPS Batteries

Questions about this item

How do I install the 7.4V 2200mAh battery into my JDSU NT1150 validator, and what step is often missed?

Power off the validator, open the battery compartment, align the connector, and press firmly until it clicks. The step often missed is confirming the latch fully engages so the pack cannot shift during vibration.

What maintenance or replacement will the Li-ion 16.28Wh pack need later?

No routine maintenance is required. Plan to replace the pack when run-time drops below roughly 80 % of its original capacity, which typically occurs after several hundred charge cycles.

What limit appears first when the battery runs a JDSU NT955 validator continuously?

The 2.2Ah capacity sets the runtime ceiling; under sustained load the pack will reach its depth-of-discharge cutoff before any thermal or voltage limit is triggered.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.