We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Cameron & Co

Cameron & Co DS-CS-ETH30BL barcode scanner battery 7.4V 2200mAh Li-ion black

SKU CH-MV25-VVZBK MPN DS-CS-ETH30BL

Replacement Li-ion battery delivering 7.4V 2200mAh for Intermec Antares and EPSON EHT barcode scanners

  • Li-ion chemistry delivers stable 7.4V 2200mAh power for long shifts
  • 28Wh capacity keeps compatible scanners running through heavy workloads
  • Fits Intermec Antares 2400 2420 2425 2430 2435 5020 5023 5025 and EPSON EHT-30 EHT-40
  • Compact 74.00 x 38.20 x 20.30 mm design slides into battery bay without modification
  • Replaces OEM part numbers including Antares 063278 068537 073152 EPSON CA54200-0090 NP-510 NP-520 NP-530

What this battery replaces

The Cameron & Co DS-CS-ETH30BL is a 7.4V 2200mAh lithium-ion pack built to replace original cells in Intermec Antares and EPSON EHT handheld scanners. It fits models such as the 2400, 2420, 2425, 2430, 2435, 5020, 5023 and 5025 series.

Sustained shift performance

Rated at 16.28 Wh, the pack delivers consistent voltage through a full scanning shift without the sharp drop-off seen in aged originals. Li-ion chemistry avoids memory effect, so partial recharges between breaks do not reduce usable capacity.

Drop-in installation

The 74.00 x 38.20 x 20.30 mm black housing matches the OEM footprint, so the battery seats in the compartment without forcing the latch. A common issue is forgetting to fully seat the connector, which leaves the scanner dead on the next power-up.

Highlights

  • Li-ion chemistry delivers stable 7.4V 2200mAh power for long shifts
  • 28Wh capacity keeps compatible scanners running through heavy workloads
  • Fits Intermec Antares 2400 2420 2425 2430 2435 5020 5023 5025 and EPSON EHT-30 EHT-40
  • Compact 74.00 x 38.20 x 20.30 mm design slides into battery bay without modification
  • Replaces OEM part numbers including Antares 063278 068537 073152 EPSON CA54200-0090 NP-510 NP-520 NP-530

Specifications

BrandCameron Sino
ModelDS-CS-ETH30BL

Questions about this item

Does the 7.4 V 2200 mAh Li-ion pack generate noticeable heat during continuous scanning shifts?

The 16.28 Wh Li-ion cell runs at low current draw typical for barcode terminals, so warmth stays minimal even after hours of non-stop use.

What must I already own for this DS-CS-ETH30BL battery to work?

You need one of the listed Intermec Antares, Trakker or EPSON EHT-30/EHT-40 hand-held computers that accept the original FMWBP4 or NP-500 series pack.

Will this 74.00 × 38.20 × 20.30 mm pack fit alongside the original charging cradle used with an Antares 2420?

Yes, the dimensions match the OEM FMWBP4 footprint, so the existing cradle and battery door close normally.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.