We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanized steel offset cable tray cutter with long handles

CABLOFIL

CABLOFIL COUPFIL Offset Cable Tray Cutter, Pre Galvanized

SKU CH-G9HV-02AJW

Offset cutter cleanly slices Cablofil cable trays in widths from 4 to 24 inches with pre-galvanised steel construction

  • Cuts Cablofil cable trays cleanly with offset design
  • Pre-galvanized steel finish resists corrosion on job sites
  • Handles tray widths from 4 in up to 24 in
  • 24 7/16 in length gives leverage for thick wire
  • Single-piece steel construction needs no extra hardware

Cable Tray Cutter for Cablofil Systems

The CABLOFIL COUPFIL is an offset hand tool designed to cut Cablofil cable trays cleanly. Its pre-galvanised steel construction resists corrosion on job sites. The cutter handles tray widths from 4 in up to 24 in. It is aimed at electricians and installers who need a dedicated tray cutter.

Thermals Noise and Power Draw

As a manual hand tool the cutter produces no heat and draws no power during use. Noise is limited to the mechanical snap of the cutting action. No motor, battery or hydraulic system is present to generate thermal load. The galvanised finish does not affect operating temperature.

Behaviour Under Sustained Load

Repeated cuts across multiple tray widths up to 24 in do not degrade the blade alignment because the tool has no powered components. Fatigue depends only on operator effort rather than thermal throttling. The offset geometry maintains leverage throughout a full day of installations. No duty-cycle limit applies.

Highlights

  • Cuts Cablofil cable trays cleanly with offset design
  • Pre-galvanized steel finish resists corrosion on job sites
  • Handles tray widths from 4 in up to 24 in
  • 24 7/16 in length gives leverage for thick wire
  • Single-piece steel construction needs no extra hardware

Specifications

BrandCABLOFIL

Questions about this item

How do I install the CABLOFIL COUPFIL cutter on a 12 in tray, and what step is often missed?

Align the offset jaws with the tray wires, then squeeze the handles fully until the cut completes; the step often missed is confirming the blade seats squarely on both side rails before applying force.

What maintenance or replacement will the CABLOFIL COUPFIL cutter need later?

The hardened steel blades will dull after repeated cuts on galvanized trays; replace the blade set when cutting requires excessive force or leaves burrs on 18 in and wider trays.

What limit shows up first when cutting 24 in trays continuously?

Handle fatigue becomes the limiting factor first, as the 24 7/16 in length demands high leverage per cut, slowing pace on 20 in, 22 in and 24 in widths.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.