We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short black cable with right-angle 3.5mm TRS plug and XLR male connector

Cable Techniques

Cable Techniques 18" Mini 3.5mm TRS to XLR-3M Output Cable

SKU CH-3P41-305XV

An 18-inch unbalanced cable connects 3.5 mm TRS locking outputs to a Neutrik XLR-3M plug for Sennheiser G4/G3 and RodeLink receivers

  • Moulded mini 3.5 mm TRS locking connector secures to Sennheiser G4/G3 and RodeLink receivers
  • Neutrik XLR-3M plug provides professional balanced-style output for field recorders
  • Right-angle 3.5 mm design eases connection in tight camera-mount spaces
  • Ultra-flexible PVC jacket keeps cable supple for mobile recording rigs
  • Lo-Pro construction up to 40% lighter than standard cables reduces panel profile and load

18-inch TRS-to-XLR output cable

This 18-inch cable connects Sennheiser G4/G3 and RodeLink camera-mount receivers to professional audio equipment. A moulded 3.5 mm TRS plug with a locking collar mates securely with the receiver output. A Neutrik XLR-3M connector terminates the other end for mixer or recorder input. The ultra-flexible PVC jacket keeps the cable light and low-profile for field use.

Thermals noise and power draw

As a passive unbalanced audio interconnect the cable generates no heat and draws no power. No active electronics or fans are present so operation is completely silent. The flexible jacket resists kinking during handheld or bag-mounted recording. Signal integrity depends on the connected devices rather than the cable itself.

Locking 3.5 mm TRS connector for Sennheiser

The right-angle mini TRS plug includes a locking collar that prevents accidental disconnection on Sennheiser EK 100 G4/G3 and RodeLink receivers. Builders needing a straight plug or a different receiver pinout should choose another cable. The 18-inch length suits belt-pack to camera-top runs without excess slack.

Highlights

  • Moulded mini 3.5 mm TRS locking connector secures to Sennheiser G4/G3 and RodeLink receivers
  • Neutrik XLR-3M plug provides professional balanced-style output for field recorders
  • Right-angle 3.5 mm design eases connection in tight camera-mount spaces
  • Ultra-flexible PVC jacket keeps cable supple for mobile recording rigs
  • Lo-Pro construction up to 40% lighter than standard cables reduces panel profile and load

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the 3.5 mm TRS locking plug to a Sennheiser G4 receiver without damaging the collar?

Align the right-angle plug with the receiver jack, push straight in until the collar clicks, then tighten the knurled ring by hand only; forcing it sideways strips the threads.

What part of this cable wears out first and how do I replace it?

The moulded strain relief at the 3.5 mm end fatigues after repeated bending; the whole 18 inch assembly is replaced as a single unit.

At what length does signal loss become noticeable on this unbalanced run?

The 18 inch length stays well below the 10 metre threshold where unbalanced lines typically pick up hum, so loss is not the limiting factor.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.