We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black SATA power splitter cables, 90-degree male to dual female connectors, 20cm length

Cable Matters E-SATAMTF-1T2-A2 15-Pin SATA Male to Dual Female 90-Degree Power Splitter Cord 20cm 2 Pack

SKU CH-JEMN-EN8T8

Splits one SATA power connector into two 90-degree angled female ports using 20 cm copper cable for drives and PCI-e cards

  • TypeSpeaker Wires
  • ColorBlack
  • Connector DetailDVI to DVI
  • Terminal GenderFemale to Female
  • Specificationsblack red and yellow, 0.15 pounds
  • ConductorCopper Conductor
  • Powers two drives from one SATA connector using 15-pin male-to-dual-female splitter
  • 90-degree angled connectors improve cable routing inside tight cases
  • 20 cm copper conductors deliver reliable power to SSDs, HDDs and optical drives
  • Simple plug-and-play installation requires no tools or drivers
  • Supplied as a pair of black splitter cords for multiple drive upgrades

15-Pin SATA Power Splitter for Dual Drives

This adapter cable splits a single 15-pin SATA power connection into two female ports, letting you run two drives from one PSU lead. It is built for SSDs, 3.5-inch hard disks, optical drives and PCIe cards that draw power through a standard SATA connector. The pack contains two identical splitters for multiple drive bays.

90-Degree Latch Connector Replaces Straight Plugs

The right-angle head with locking latch fits tight spaces behind drive cages where straight connectors foul on side panels or other cables. Swap it in when your current SATA power leads are too short or block airflow, and you need a secure, low-profile joint that will not work loose during transport or vibration.

Check Drive Power Draw Before Connecting Two Units

Verify that the combined current draw of both attached devices stays within the rating of the single PSU rail feeding the splitter. Ensure your power supply has a free 15-pin SATA lead and that the 20 cm reach covers the distance from that lead to both drive positions without strain.

Highlights

  • Powers two drives from one SATA connector using 15-pin male-to-dual-female splitter
  • 90-degree angled connectors improve cable routing inside tight cases
  • 20 cm copper conductors deliver reliable power to SSDs, HDDs and optical drives
  • Simple plug-and-play installation requires no tools or drivers
  • Supplied as a pair of black splitter cords for multiple drive upgrades

Specifications

BrandCable Matters
ModelE-SATAMTF-1T2-A2
TypeSpeaker Wires
ColorBlack
Connector DetailDVI to DVI
Terminal GenderFemale to Female
Specificationsblack red and yellow, 0.15 pounds
ConductorCopper Conductor
Featuresblack red and yellow
Disclaimernot_applicable

Questions about this item

Does the 90-degree SATA male connector need extra clearance behind the drive?

The 90-degree angle points the cable sideways so it fits tight against a 3.5-inch drive or optical bay without pressing on the connector.

Is there a latch I must engage when plugging the splitter into the PSU?

Yes, the male end has a locking latch; push until it clicks or the connection can work loose under vibration.

Will the copper conductors fatigue if I reroute the 20cm cables during upgrades?

Copper handles repeated bending, but avoid sharp kinks at the 90-degree moulding to keep the conductors intact.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.