We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Burndy copper pipe ground clamp, 3.75 inch, commercial grade

Burndy

Burndy Pipe Ground Clamp 3.75In

SKU CH-ZP4Z-GZDWE

Grounding clamp connects 8 AWG to 750 kcmil copper wire to 1/2 in to 1 in pipe, UL 467 listed for direct burial

  • TypeCommercial
  • UL 467 listed for direct-burial grounding
  • Accepts 8 AWG to 750 kcmil copper conductors
  • Fits 1/2 in to 1 in pipe or ground rod
  • Copper construction resists corrosion
  • 3/8 in bolt secures connection

Ground Clamp for 1/2 in to 1 in Pipe

This Burndy ground clamp connects a single copper conductor to water pipe or ground rod. It accepts wire sizes from 8 AWG up to 750 kcmil and is UL 467 listed for direct burial. The mechanical connector suits commercial electrical grounding work where a reliable pipe bond is required.

Thermals Noise and Power Draw

As a passive mechanical connector the clamp generates no heat and draws no power during operation. There are no moving parts or active cooling to produce audible noise. Performance depends only on the torque applied to the 3/8 in bolt and the condition of the pipe surface.

Build Quality and Mounting Implications

The copper body resists corrosion in buried or damp environments. The 3/8 in bolt clamps onto pipe diameters between 1/2 in and 1 in without additional adapters. Direct burial rating means the assembly can remain underground without separate enclosures or protective coatings.

Highlights

  • UL 467 listed for direct-burial grounding
  • Accepts 8 AWG to 750 kcmil copper conductors
  • Fits 1/2 in to 1 in pipe or ground rod
  • Copper construction resists corrosion
  • 3/8 in bolt secures connection

Specifications

BrandBurndy
TypeCommercial

Questions about this item

How do I install the clamp on a 1/2 in to 1 in pipe and tighten the 3/8 in bolt without stripping it?

Place the clamp around the pipe, insert the grounding wire between the jaws, then tighten the 3/8 in bolt with a wrench until the conductor is held firmly; over-torquing the bolt is the common error.

Will the copper body or the 3/8 in bolt need replacement after direct-burial service?

The copper clamp is rated for direct burial and requires no scheduled replacement; only the 3/8 in bolt might need attention if it corrodes after many years underground.

At what point does the 750 kcmil maximum conductor limit become the bottleneck during sustained fault current?

The clamp is UL467 listed for conductors up to 750 kcmil; that wire size is the first thermal and mechanical limit reached under prolonged high-current conditions.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.