We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aluminium multi-tap connector, clear unplated finish, two ports, 1.25 inch body

Burndy

Burndy Multi Tap Connector 14AWG 1.25In 2 Ports L

SKU CH-T1WF-1HA5X

Aluminium multi-tap connector accepts 14-4 AWG copper or aluminium conductors, rated 600 V with UL and CSA approvals

  • Type2 Ports, Single Sided Entry, L
  • 2 ports let you join two conductors in one block
  • single-sided entry keeps wiring tidy on one face
  • aluminum body accepts both copper and aluminium wires
  • Plastisol insulation rated V-0 resists flame up to 194 °F
  • UL 486A/B and CSA approvals confirm 600 V safety

Burndy 1.25-Inch Two-Port Connector

This Burndy multitap connector provides two ports with single-sided entry in an L configuration. It is built for electrical and industrial wiring tasks where aluminium or copper conductors must be joined. The clear, unplated aluminium body uses plastisol insulation rated UL 94 V-0 for flame resistance. RoHS compliance and CSA approval confirm it meets recognised safety and environmental standards.

Capacity and Headroom: 14 AWG to 4 AWG

The connector accepts stranded copper wire from 14 AWG up to 4 AWG, giving installers a wide range for common branch-circuit sizes. It is rated for 600 V maximum and an operating temperature of 194 degrees F, so it handles typical residential and light-commercial loads. The hex-head set screws use a 1/8-inch key, allowing secure termination without specialised tooling beyond a standard Allen driver.

Practical Limits of the UL 486 Standard

UL 486A and UL 486B listings cover wire-connector safety for aluminium and copper conductors, but they do not extend to voltages above 600 V or temperatures beyond 194 degrees F. The plastisol insulation and unplated aluminium body are not rated for continuous exposure to harsher environments. Buyers needing higher voltage ratings, larger conductor sizes or different mounting provisions must select a different listed device.

Highlights

  • 2 ports let you join two conductors in one block
  • single-sided entry keeps wiring tidy on one face
  • aluminum body accepts both copper and aluminium wires
  • Plastisol insulation rated V-0 resists flame up to 194 °F
  • UL 486A/B and CSA approvals confirm 600 V safety

Specifications

BrandBurndy
Type2 Ports, Single Sided Entry, L

Questions about this item

Will the 1/8 in hex head fit the drivers I already use for 14 AWG terminals?

The connector uses a 1/8 in hex head, a common size for small-gauge lugs, so most standard hex drivers or bits for 14 AWG work will engage it.

How can I confirm the Plastisol insulation is seated correctly after I torque the two ports?

After tightening, the clear Plastisol body should show no gaps around each conductor and the V-0 rated material will sit flush with the 1.25 in length.

Does the package include mounting hardware or only the two-port L connector?

The supplied unit is the aluminium L connector with Plastisol insulation; mounting hole size is not applicable and no separate hardware is included.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.