BUCIER USB 3.0 Header Extension Cable 19/20 Pin 1 to 2 Y Splitter 5.9 inch

Motherboard USB 3.0 Header Splitter

This BUCIER cable converts one internal USB 3.0 19/20 pin header into two female ports using a Y splitter design. It measures 5.9 inches and uses flat ribbon wiring for a tidy internal layout. The adapter targets builders who need extra front-panel or accessory connections on boards with limited headers. Data rates reach 5 Gbps with full-duplex signalling.

Suits tight header layouts; avoid if fit is critical

The splitter works well in SLI configurations or compact builds where a single header must serve multiple devices. Builders who need guaranteed retention on every motherboard should look elsewhere because the male connector can sit loosely on some boards. The product notes specifically flag incompatibility with the iCUE 7000X case. No universal header standard exists, so verification before purchase is essential.

Handles two devices at 5 Gbps each

Each female port delivers the full USB 3.0 bandwidth of 5 Gbps for simultaneous bi-directional transfers. The short 5.9 inch length keeps signal integrity high but limits reach to nearby headers or front-panel modules. Longer runs or additional splits would require a different cable. The flat ribbon construction resists heat buildup and simplifies cable management in dense chassis.