We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black adapter cable with 10-pin header and two USB-A ports, 50cm length

BUCIER

BUCIER 10 Pin Motherboard Header to Dual USB 2.0 Female Adapter Cable 50cm

SKU CH-0Q4V-830S5

Converts a 10 pin motherboard header into two USB 2.0 female ports using 28AWG copper wire over 50cm

  • Connector TypeUSB Type A
  • ColorUSB2.0 Heaer to Type-A Female
  • Connector DetailUSB Type A
  • Constructioncopper
  • Converts one 10-pin header into two USB 2.0 ports
  • 50 cm cable reaches front-panel cut-outs easily
  • Dual USB Type-A jacks accept standard peripherals
  • 28 AWG bare copper conductors carry data reliably
  • Internal header adapter adds external ports without PCIe slot

Internal USB 2.0 header expansion

This adapter converts a single 10 pin motherboard header into two standard USB 2.0 Type A female ports. It is intended for builders who need additional front panel or internal USB connections without using rear I/O slots. The 50cm cable length suits typical chassis routing from the motherboard to front drive bays or custom panels. The product is new and uses bare copper conductors.

Signal integrity over the 50cm run

The cable uses 28+28AWG bare copper wire to carry USB 2.0 signals between the header and the two Type A jacks. This gauge is chosen to maintain reliable data transfer across the full length under sustained peripheral use. No active circuitry is present so performance depends on the host controller and the quality of the connected devices. The adapter simply extends the existing bus without adding latency or bandwidth overhead.

Copper construction and dual port layout

The housing presents two USB Type A female sockets side by side, each wired from the single 10 pin header connector. Copper conductors provide durability for repeated plug cycles in daily use. The 50cm length offers enough slack for tidy cable management behind a motherboard tray or along a drive cage. Builders who require more than two additional ports or a different header pinout will need a separate solution.

Highlights

  • Converts one 10-pin header into two USB 2.0 ports
  • 50 cm cable reaches front-panel cut-outs easily
  • Dual USB Type-A jacks accept standard peripherals
  • 28 AWG bare copper conductors carry data reliably
  • Internal header adapter adds external ports without PCIe slot

Specifications

BrandBUCIER
Connector TypeUSB Type A
ColorUSB2.0 Heaer to Type-A Female
Connector DetailUSB Type A
Constructioncopper

Questions about this item

Does the 28 AWG copper conductor in the 50 cm cable add noticeable heat or power draw when both USB 2.0 ports run all day?

The 28 AWG bare copper wires are sized for USB 2.0 current levels, so the adapter itself adds negligible heat or power overhead during continuous use.

What must my motherboard provide for this 10 pin header adapter to work?

A spare 9 pin (10 pin with one key pin) internal USB 2.0 header on the motherboard is required; the cable plugs directly into that header.

Will the dual USB 2.0 female ports work with older USB 1.1 peripherals I still use?

Yes, the USB 2.0 female ports are backward compatible, so USB 1.1 devices will function at their native speed through the adapter.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.