Bryant
Bryant 9901W 20 A 120/277 V Rocker Wall Switch
A 20 A single-pole rocker wall switch rated for 120/277 V AC with screw terminals and a 1.7 in height
- 20 A rating handles heavy-duty industrial loads
- 120/277 V AC dual-voltage suits varied power systems
- Single-pole rocker action gives clear on/off control
- Stainless steel spring wire resists fatigue over repeated cycles
- 7 in height fits standard wall-box openings
Industrial Rocker Switch
The Bryant 9901W is a single-pole rocker wall switch rated for 20 A at 120/277 V AC. It is built for industrial lighting and motor-control circuits where a maintained contact is required. The white finish and 1.7 in overall height suit standard commercial wall boxes.
2 hp Motor Capacity
The switch carries a 2 hp rating, letting it directly control small single-phase motors such as fans, pumps or conveyors without a separate contactor. At 20 A the device reaches its thermal limit, so loads above this level need a heavier-duty starter.
Screw-Terminal Back and Side Wiring
Conductors are landed on screw terminals accessible from the back or side of the body, accepting solid or stranded wire for flexible installation. The stainless-steel spring wire maintains contact pressure over time. UL/CSA listing confirms compliance with North American safety standards.
Highlights
- 20 A rating handles heavy-duty industrial loads
- 120/277 V AC dual-voltage suits varied power systems
- Single-pole rocker action gives clear on/off control
- Stainless steel spring wire resists fatigue over repeated cycles
- 7 in height fits standard wall-box openings
Specifications
| Brand | BRYANT |
|---|
Questions about this item
Will this 20 A rocker switch fit in a standard wall box alongside my existing receptacles?
The Bryant 9901W has an overall height of 1.7 in and uses screw-terminal wiring via back or side entries, so it fits standard boxes used for typical receptacles.
How can I verify the 9901W is operating correctly after installation?
Flip the rocker to the maintained position; the connected 120/277 V AC load up to 20 A or 2 hp should energise immediately and stay on until the rocker is pressed again.
What comes with the 9901W and what must I purchase separately?
The switch itself is supplied; mounting screws, wire connectors and a wall plate are not included and must be bought separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
