Bryant
Bryant 4902BGRY 20A 2-Pole Toggle Switch Gray
A 20 A double-pole toggle switch rated for 120/277 V AC with screw terminals and a 1.7 in height
- Rated 20 A for reliable circuit control
- Double-pole toggle handles two circuits simultaneously
- 120/277 V AC rating suits commercial wiring
- Screw terminals accept back and side connections
- UL/CSA listed for industrial safety compliance
Bryant 4902BGRY 20A 2-Pole Toggle
This Bryant 4902BGRY is a 20-ampere, two-pole toggle switch rated for 120/277V AC circuits. It uses screw-terminal connections that accept back and side wiring methods. The device carries UL and CSA listings and includes a brass and nickel-plated steel ground terminal. It is built for industrial and commercial wiring applications.
Suited for circuits needing both legs switched
Electricians and maintenance teams use this switch where a single throw must open two conductors at once. It is not for low-voltage control circuits, nor for circuits exceeding its 20-ampere or 277-volt ratings. It is not for three-way or four-way switching configurations. It is not for applications requiring a locking actuator or a pilot-light indicator.
Two-pole, 20A, 120/277V AC rating
The defining specification is the double-pole, 20-ampere rating at 120/277V AC. This determines whether the switch can handle the load and voltage of the intended circuit. The 1.7-inch overall height fits standard industrial wall boxes. Verify the circuit amperage and voltage match these ratings before installation.
Highlights
- Rated 20 A for reliable circuit control
- Double-pole toggle handles two circuits simultaneously
- 120/277 V AC rating suits commercial wiring
- Screw terminals accept back and side connections
- UL/CSA listed for industrial safety compliance
Specifications
| Brand | BRYANT |
|---|
Questions about this item
Does the 1.7 in. overall height fit a standard wall box?
The 1.7 in. overall height is designed to fit standard single-gang wall boxes used for 20 A toggle switches.
How do I wire the screw terminals on the 4902 model?
Loosen the brass screw terminals, insert stripped copper wires back or side, tighten securely, and connect the ground wire to the brass and nickel-plated steel ground terminal.
When should the toggle mechanism be replaced?
Replace the switch if the toggle feels loose, fails to maintain the on or off position, or shows discoloration from heat at the 120/277V AC screw terminals.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
