We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black aluminium riser block with Manfrotto-style quick-release clamp and safety lever

Bright Tangerine

Bright Tangerine Manfrotto Riser for 15mm Baseplate RED V-RAPTOR Black

SKU CH-PDYN-W0FNP

A lightweight aluminium riser that sets a RED V-RAPTOR at the correct 15 mm LWS height for Manfrotto 501PL dovetails and enables quick changes between tripod, handheld and gimbal setups

  • Sets RED V-RAPTOR at correct 15mm LWS height for baseplate alignment
  • Quick-release clamp enables fast transitions between tripod, handheld and gimbal setups
  • Ratchet Lock Lever swaps to low-profile screw for higher clamping force
  • Safety lock prevents accidental dovetail release during operation
  • Weighs only 5 oz (141g) aluminium for minimal rig bulk

Mounting Standard

This aluminium riser sets a RED V-RAPTOR at the correct 15 mm LWS height when used with a Left Field baseplate. It accepts Manfrotto 501PL and DJI RS 3/4 dovetails for quick changes between tripod, handheld and gimbal configurations. Weighing 141 g, it adds minimal bulk to the rig.

Ideal Users and Limitations

Camera operators who need fast transitions between support systems will benefit from the quick-release clamp and ratchet lock lever. Builders using non-Manfrotto or non-DJI dovetail plates cannot mount this receiver. Anyone requiring a different rod standard or a heavier payload capacity should look elsewhere.

Deciding Specification

The riser is built specifically for 15 mm LWS rod spacing and Manfrotto 501PL or DJI RS dovetails. If your baseplate or dovetail uses a different standard, the height alignment and quick-release function will not work.

Highlights

  • Sets RED V-RAPTOR at correct 15mm LWS height for baseplate alignment
  • Quick-release clamp enables fast transitions between tripod, handheld and gimbal setups
  • Ratchet Lock Lever swaps to low-profile screw for higher clamping force
  • Safety lock prevents accidental dovetail release during operation
  • Weighs only 5 oz (141g) aluminium for minimal rig bulk

Specifications

No published specifications for this item yet.

Questions about this item

Will the Manfrotto-style receiver on this riser accept my 501PL dovetail plate?

Yes, the receiver is built for Manfrotto 501PL-style plates and also works with DJI RS 4 and RS 3 gimbal dovetails, so your existing plate slides straight in.

How do I swap the pre-installed ratchet lever for the low-profile locking screw?

Unscrew the lever, thread in the supplied locking screw, and tighten it with a 4 mm hex key for a more secure clamp that cannot be knocked loose.

Does the aluminum body need any lubrication or periodic tightening over time?

No scheduled maintenance is required; just check the M4 mounting screws and the clamp screw occasionally to ensure they remain snug after heavy use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.