BoYata
BoYata USS-HMA04Print Thermal Printer RS-232 50 mm/s 57 mm Paper 2 in 1 Accessory
Thermal printer prints at 50 mm/s via RS-232 on 57 mm paper for U.S. Solid moisture analyzers
- Thermal printing at 50 mm/s for fast results
- RS-232 interface connects directly to U.S. Solid moisture analyzers
- Uses standard 57 mm paper rolls for easy supply
- Prints moisture content, weight, mode, temperature and duration
- Compact 5.9 x 4.8 x 3.7 inch footprint saves bench space
Laboratory Thermal Printer
The BoYata USS-HMA04Print is a thermal printer built for laboratory moisture analysers. It connects through an RS-232 port and works with every U.S. Solid moisture analyser model. The unit prints at 50 mm/s on standard 57 mm wide paper. It is intended for technicians who need permanent records of each test run.
Thermal Operation and Power
Thermal printing requires no ink or toner, so consumable cost and waste are reduced. The mechanism runs at 50 mm/s while drawing minimal power from the analyser link. No cooling fan is fitted, so the printer adds no audible noise to the bench. Energy use stays low during both active printing and idle periods.
Bundled Interface Cable
The package includes the RS-232 cable needed to link the printer to the analyser. No driver installation is required; the analyser pushes formatted data directly to the port. Each printout captures moisture content, weight, testing mode, temperature and duration automatically. This removes manual transcription and reduces recording errors.
Highlights
- Thermal printing at 50 mm/s for fast results
- RS-232 interface connects directly to U.S. Solid moisture analyzers
- Uses standard 57 mm paper rolls for easy supply
- Prints moisture content, weight, mode, temperature and duration
- Compact 5.9 x 4.8 x 3.7 inch footprint saves bench space
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect the RS-232 cable to the moisture analyzer?
Plug the RS-232 connector into the matching port on the analyser; the printer is compatible with all U.S. Solid moisture analyzers and requires no driver installation.
What consumable does the USS-HMA04Print need over time?
It uses standard 57 mm wide thermal paper rolls; the roll is replaced by opening the cover and loading a new one.
What limits continuous printing on this thermal unit?
The 50 mm/s thermal mechanism will throttle or pause if the print head overheats during sustained high-volume output.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
