We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small metal SMA splitter with two female connectors, silver finish

BoYata

BoYata 2 in 1 accessory SMA splitter 0.4-2.7GHz

SKU CH-KEA6-C0Z58

Passive power splitter divides a 0.4-2.7 GHz signal into two 50 ohm SMA outputs with 4.2 dB insertion loss

  • Splits one RF signal into two paths with 4.2 dB maximum insertion loss
  • Covers 0.4 to 2.7 GHz range for microwave measurement setups
  • Two SMA female connectors at 50 ohm impedance for direct antenna links
  • Corrosion-resistant construction maintains signal integrity in antenna systems
  • Plug-and-play installation requires no configuration for immediate use

RF power splitter for test and antenna systems

This passive two-way divider splits an incoming signal into two SMA female ports across a 0.4-2.7 GHz range. It suits engineers and technicians who need to feed a single source into dual antennas or measurement paths without active amplification. The 50 ohm impedance matches common RF coaxial cabling used in bench and field work.

Insertion loss and isolation under continuous use

Maximum insertion loss is specified at 4.2 dB, so each output receives roughly one-quarter of the input power in steady-state operation. The corrosion-resistant housing maintains stable performance during prolonged sessions, and the passive design adds no noise or distortion regardless of duty cycle. Isolation between ports remains consistent because no active components age or drift with temperature.

Connector gender frequency range and impedance match

Verify that your cables and instruments use SMA male plugs compatible with the splitter’s SMA female ports. Confirm the system operates within the 0.4-2.7 GHz band and expects a 50 ohm characteristic impedance throughout. The unit requires no external power, so ensure the source can tolerate the inherent 4.2 dB split loss without additional gain stages.

Highlights

  • Splits one RF signal into two paths with 4.2 dB maximum insertion loss
  • Covers 0.4 to 2.7 GHz range for microwave measurement setups
  • Two SMA female connectors at 50 ohm impedance for direct antenna links
  • Corrosion-resistant construction maintains signal integrity in antenna systems
  • Plug-and-play installation requires no configuration for immediate use

Specifications

No published specifications for this item yet.

Questions about this item

Does the splitter generate heat or noise when left running continuously?

As a passive component it has no active circuitry, so it produces no heat and makes no sound during continuous operation.

What cables or connectors must I already have to use the SMA ports?

You need coaxial cables terminated with SMA male plugs to connect to the two female SMA ports on the divider.

Will this work with older 50 ohm RF equipment I already own?

Yes, the 50 ohm impedance matches standard legacy RF gear, and the 0.4-2.7 GHz range covers most older measurement and antenna systems.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.