We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four silver SFP+ transceiver modules with RJ45 ports side by side

BoYata

BoYata 10Gb SFP+ to RJ45 Transceiver 30m 4 Pack

SKU CH-EF82-7BWEW

Four SFP+ to RJ45 transceivers connect 10GbE gear over Cat6a or Cat7 up to 30 metres

  • Supports 1.25 to 10GbE auto-negotiation for flexible speeds
  • Reaches 30 metres over Cat6a or Cat7 copper cabling
  • Works with Cisco, Ubiquiti, MikroTik and other 10G SFP+ gear
  • Hot-pluggable, plug-and-play with no software needed
  • Each module individually tested on 2.5, 5 and 10Gbps equipment

10Gb SFP+ RJ45 4-pack

This four-pack of 10Gb SFP+ to RJ45 transceivers connects switches, routers or servers over Cat6a or Cat7 copper up to 30 metres. Each module auto-negotiates at 1.25, 2.5, 5 or 10 GbE and draws less than 2.5 watts. The hot-pluggable design fits any 10G SFP+ cage that follows the MSA specification.

Replacing fibre modules

The copper RJ45 interface replaces short-reach fibre transceivers when existing structured cabling is already in place and runs do not exceed 30 metres. The jump is worth it when you need 10G speeds without pulling new fibre or when the switch side only offers SFP+ cages. Buyers who need longer copper runs or fibre distances cannot use these modules.

Plug-and-play install

Installation is a simple hot-plug into a compliant SFP+ port; no driver or software configuration is required. The modules conform to IEEE 802.3an, 802.3az, SFF-8431 and SFF-8432 and operate from 0 to 70 °C (32 to 158 °F). The most common issue is inserting the transceiver into a non-compliant cage such as the Ubiquiti US-48-500W, which the supplier lists as incompatible.

Highlights

  • Supports 1.25 to 10GbE auto-negotiation for flexible speeds
  • Reaches 30 metres over Cat6a or Cat7 copper cabling
  • Works with Cisco, Ubiquiti, MikroTik and other 10G SFP+ gear
  • Hot-pluggable, plug-and-play with no software needed
  • Each module individually tested on 2.5, 5 and 10Gbps equipment

Specifications

No published specifications for this item yet.

Questions about this item

What SFP+ cage and cable type does this module need?

It fits any standard SFP+ cage and reaches 30 m over Cat6a or Cat7 copper cable.

Does the module need drivers or configuration before use?

No, it is hot-pluggable and works plug-and-play; just insert it into a powered SFP+ port.

How long can each transceiver run before it may need replacement?

Operating temperature is rated 0 to 70 °C; modules typically last years under normal conditions.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.