BOXLIGHT
BOXLIGHT SE-12SF Projector Lamp 270W 2000 Hrs
A 270-watt replacement lamp module with a 2,000-hour rated life for Boxlight projectors
- TypeProjector Lamp
- Wattage270W
- Lamp Life2,000 Hrs.
- Ready-to-install module with bulb and housing included
- 270W Phoenix SHP bulb delivers specified brightness
- 2000-hour rated lamp life for extended use
- Manufactured to ISO9001 quality standards
- Compatible with Boxlight SE-12SF projectors
Replacement Lamp for Boxlight Projectors
This 270W lamp module fits Boxlight projectors that require the SE-12SF or SP-LAMP-LP5F part. It arrives as a fully assembled bulb and housing, so technicians and AV staff can swap it without handling a bare burner. The unit is supplied new and ready for immediate installation.
Critical Specification: 270W Phoenix SHP Bulb
The lamp uses a Phoenix SHP 270W bulb rated for 2,000 hours of operation. Projectors designed for a different wattage or bulb type will not strike or will overheat, so verifying the 270W requirement against the service manual is the single decisive check. No other electrical or optical parameters are provided.
Straightforward Module Swap
Because the bulb comes pre-mounted in its housing, installation is a matter of opening the projector lamp door, removing the old module, and seating the new one until the connector engages. The most common issue is forgetting to reset the projector’s lamp-hour counter after replacement, which leaves the replacement warning active. Ensure the door latch closes fully, as an open interlock will prevent the lamp from striking.
Highlights
- Ready-to-install module with bulb and housing included
- 270W Phoenix SHP bulb delivers specified brightness
- 2000-hour rated lamp life for extended use
- Manufactured to ISO9001 quality standards
- Compatible with Boxlight SE-12SF projectors
Specifications
| Brand | Boxlight |
|---|---|
| Type | Projector Lamp |
| Wattage | 270W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How bright will the 270W lamp actually be in my Boxlight projector?
The 270W Phoenix SHP bulb restores the projector's original brightness and colour balance because it matches the factory specification for the SE-12SF module.
Does the SE-12SF use a standard lamp connector that fits any Boxlight model?
The module is built to the SP-LAMP-LP5F form factor, so it only fits the Boxlight projectors that list that exact part number.
What clearance does the assembled housing need inside the projector cage?
The lamp ships as a complete bulb-and-housing unit designed to slide into the SE-12SF compartment without extra brackets or adapters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



