We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Boxlight Mitsubishi HC1110 projector lamp module with UHP 200W bulb in housing

BOXLIGHT

BOXLIGHT Mitsubishi HC1110 VLT-HC910LP 200W Projector Lamp

SKU CH-982F-E43QW

A ready-to-install 200W UHP lamp module rated for 2,000 normal or 3,000 economy hours

  • TypeUHP
  • Wattage200W
  • Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
  • Ready-to-install module with bulb and housing included
  • OEM Ushio 200W UHP lamp for reliable brightness
  • 2,000 hours normal or 3,000 hours economy life
  • Built to ISO 9001 quality standards with strict testing
  • Compatible with Mitsubishi HC1110 projector model VLT-HC910LP

Ready-to-Install Projector Lamp Module

The BOXLIGHT Mitsubishi HC1110 VLT-HC910LP is a complete replacement lamp module that pairs a new 200W Ushio UHP bulb with its housing. It is designed for owners of Mitsubishi HC1110 projectors who need a direct, plug-and-play swap without assembling components themselves. The module arrives fully assembled so the projector can return to service immediately after installation.

Rated Output Across Two Operating Modes

The 200W UHP lamp delivers 2000 hours of life in normal mode and extends to 3000 hours when the projector runs in economy mode. Brightness and thermal load scale with the selected mode, so sustained use in economy reduces stress on the bulb and stretches the interval between replacements. Actual runtime will follow the projector’s usage pattern and ventilation conditions.

Simple Housing Swap With No Alignment Steps

Installation consists of removing the old lamp housing and inserting the new module until it seats firmly; no bulb-to-reflector alignment or separate bulb handling is required. The most common issue is forgetting to reset the projector’s lamp-hour counter after the swap, which leaves the replacement warning active. A second pitfall is neglecting to clean the air filter at the same time, allowing dust to shorten the new lamp’s life.

Highlights

  • Ready-to-install module with bulb and housing included
  • OEM Ushio 200W UHP lamp for reliable brightness
  • 2,000 hours normal or 3,000 hours economy life
  • Built to ISO 9001 quality standards with strict testing
  • Compatible with Mitsubishi HC1110 projector model VLT-HC910LP

Specifications

BrandMitsubishi
TypeUHP
Wattage200W
Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.

Questions about this item

How much heat and fan noise does the 200W UHP lamp generate during long sessions?

The lamp draws 200W, so the projector’s cooling fan will run at its normal speed; expect typical warm air output and audible fan noise comparable to the original Mitsubishi lamp.

What must I already own to install this VLT-HC910LP module?

You need a Mitsubishi HC1110 projector; the module arrives as a complete bulb-and-housing assembly, so no extra tools or separate bulb are required.

Will this replacement lamp work reliably in my older HC1110 unit?

Yes, it is built to the same VLT-HC910LP specification and tested for ignition, voltage and run-time, delivering 2,000 hours normal or 3,000 hours economy life in the original projector.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.