We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three flat SATA to LP4 power cables with black connectors

BONAEVER

BONAEVER SATA to LP4 Power Cable 3 Pack bag

SKU CH-D5RC-V0JJ8

Converts SATA power connectors to 15-pin Molex for IDE drives, three cables included

  • Case TypeProtection Case
  • Converts SATA power to LP4 for IDE drives
  • Three cables included for multiple device connections
  • 15-pin SATA male to 4-pin Molex female adapter
  • Eight-inch cable length suits internal chassis routing
  • Enables powering optical drives from SATA supply

SATA to LP4 adapter cable trio

This three-pack supplies SATA 15-pin male to Molex LP4 female adapters, letting a SATA power source run older IDE hard drives or optical drives. Each cable measures eight inches and the pack is sold new. Builders expanding legacy storage inside a chassis will find the connectors match the described pin-out.

Who benefits and who should look elsewhere

Suits technicians converting spare SATA power leads for IDE devices when the original four-pin plugs are scarce. Not intended for anyone needing SATA power outputs, right-angle connectors or longer reach than the fixed eight-inch length provides. Buyers requiring a different pin arrangement or additional cables per pack should seek another kit.

Deciding specification — 15-pin SATA male input

The sole interface on the supply side is a 15-pin SATA male connector; if your power supply lacks that exact header the adapters cannot be used. Verify the source connector before purchase.

Highlights

  • Converts SATA power to LP4 for IDE drives
  • Three cables included for multiple device connections
  • 15-pin SATA male to 4-pin Molex female adapter
  • Eight-inch cable length suits internal chassis routing
  • Enables powering optical drives from SATA supply

Specifications

Case TypeProtection Case

Questions about this item

Will the 15-pin SATA connector draw noticeable extra power if the adapter runs all day?

The adapter is a passive cable with no active electronics, so it adds no measurable power draw or heat beyond the drive itself.

Does my power supply need a spare 15-pin SATA lead for each of the three cables?

Yes, each cable requires one free 15-pin SATA power connector from the supply to feed the Molex device.

Can I use these with an older IDE hard drive that only has a 4-pin Molex socket?

The Molex end is female, so it plugs into a male Molex plug on a power supply, not into the male Molex socket on an IDE drive.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.