Bn Products Usa
Bn Products Usa Rebar Cutter Bender 180 Deg 10Amp 5/8Cap
Portable rebar cutter and bender handles up to 5/8 in grade 60 bar with 10 amp motor and 180 degree bend capacity
- Cuts and bends rebar up to 5/8 in
- 10 amp motor handles Grade 60 rebar
- 180 degree bending for versatile shaping
- 115 V AC power suits jobsite outlets
- 30 mm blade diameter for clean cuts
Portable Rebar Tool for Cutting and Bending
This portable unit handles both shearing and bending of reinforcing steel up to 5/8 inch diameter. It is built for contractors and crews who need a single machine to cut and form grade 60 rebar on the job site.
Simple Electric Setup with Rotating Head Limits
The tool plugs into a standard 115 V AC outlet and draws 10 amps, so no separate hydraulic pump or generator is required. Installation is limited to securing the base and verifying blade alignment; the cutting head does not rotate, which restricts access in tight wall configurations.
Sustained Operation on Grade 60 Material
Ball bearings support the drivetrain during repeated cycles on grade 60 rebar at the full 5/8 inch capacity. The 30 mm blade diameter and 180 degree bending range maintain consistent force without the pressure drop common in hydraulic rams during long production runs.
Highlights
- Cuts and bends rebar up to 5/8 in
- 10 amp motor handles Grade 60 rebar
- 180 degree bending for versatile shaping
- 115 V AC power suits jobsite outlets
- 30 mm blade diameter for clean cuts
Specifications
| Brand | BENNER-NAWMAN |
|---|
Questions about this item
How can I confirm the cutter-bender is operating correctly after first use?
Verify that the motor runs on 115V AC and cleanly shears and bends grade-60 rebar up to 5/8 in through a full 180° bend without binding.
What comes in the box and what must I supply separately?
The unit includes the portable cutter-bender head with 30 mm blade and ball bearings; you must provide a 115V AC power source and the rebar stock to be cut or bent.
Which capacity should I choose for grade-60 rebar work?
The tool is rated for both cutting and bending grade-60 rebar at a maximum of 5/8 in, so select this model when your material does not exceed that diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
