Bluecctv
Bluecctv XA RPT11A HD-SDI Video Repeater 1CH In 2CH Out
Extends HD-SDI video signals up to 300 feet with one BNC input and two BNC outputs at 1080P 30P
- TypeAudio/Video Extension Card
- Extends HD-SDI signal up to 300 ft over RG59 cable
- Splits one HD-SDI input into two identical BNC outputs
- Supports 1080p 30p video on both input and output channels
- LED indicators show power status and active HD-SDI reception
- Operates from -10 °C to +50 °C in up to 80 % humidity
Bluecctv XA RPT11A HD-SDI Repeater
The Bluecctv XA RPT11A is an HD-SDI video repeater that accepts one 1080P 30P BNC input and duplicates it to two BNC outputs. It extends HDcctv signal transmission up to 300FT for longer cable runs in surveillance installations.
Extends HD-SDI runs beyond standard cable limits
Standard HD-SDI cables such as RG59 typically reach 100M while Canare cable reaches 200M before signal degradation. This repeater boosts the signal so installers can bridge longer distances without replacing existing cabling or adding active converters.
Check power and environmental fit before ordering
The unit requires a DC 12V 120mA supply which is not included in the package. Operating temperature ranges from -10C to +50C with 30 to 80 percent relative humidity. The device is not waterproof so it must be mounted in a protected indoor or sheltered location.
Highlights
- Extends HD-SDI signal up to 300 ft over RG59 cable
- Splits one HD-SDI input into two identical BNC outputs
- Supports 1080p 30p video on both input and output channels
- LED indicators show power status and active HD-SDI reception
- Operates from -10 °C to +50 °C in up to 80 % humidity
Specifications
| Brand | Bluecctv |
|---|---|
| Model | XA RPT11A |
| Type | Audio/Video Extension Card |
Questions about this item
What BNC cable length can the XA RPT11A handle before it needs power?
The repeater extends HD-SDI signals up to 300 feet using RG59 cable at 100 metres or Canare cable at 200 metres, then requires DC 12 V at 120 mA to continue.
Which connector do I plug the camera into on the XA RPT11A?
Connect the camera to the single BNC video input labelled 1CH HD-SDI 1080P 30P; the two BNC outputs then feed separate monitors or recorders.
How will I know if the XA RPT11A is receiving a valid HD-SDI signal?
The green LED lights only when a 1080P 30P HD-SDI stream is detected, while the red LED simply confirms 12 V power is present.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
vtech VC7002 open/closed sensor surveillance security system
- Home Improvement



