We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two small rectangular units, one labelled transmitter and one receiver, matte black finish, passive VGA extender set

Bluecctv

Bluecctv AP-TTP111VGA Cat5 VGA Extender 135m 400ft

SKU CH-F6BA-CZP73

Transmits VGA video up to 135 metres over CAT5 cable using a passive transmitter and receiver pair supporting 1280 × 1024 resolution

  • Extends VGA signals up to 135 metres over standard CAT5 cable
  • Passive design needs no external power supply
  • Includes both transmitter and receiver units in one package
  • Supports resolutions up to 1280 × 1024 pixels
  • Built-in sync controls keep the picture stable over long runs

Passive VGA Extender Kit for Long Runs

The Bluecctv AP-TTP111VGA kit includes a transmitter and a receiver that carry a VGA signal up to 135 metres over standard four-pair CAT5 cable. No external power is required for either unit, making installation simple in classrooms, lecture halls or retail kiosks. The transmitter provides a virtual DDC and sync-mode selection to keep the display configuration stable. The receiver adds a sync-filter level adjustment for extra signal stability.

Resolution and Cable Limits

The extender supports a maximum resolution of 1280 × 1024 pixels over the full 135-metre distance using CAT5 STP or UTP cable. Because the devices are passive, signal quality depends on the cable grade and the length used; runs at or near the maximum distance may not sustain the highest resolution. The link replaces bulky VGA cabling but cannot exceed the stated distance or resolution figures.

Compatibility Checks Before Buying

Verify that both the source and the display use standard VGA connectors and can operate at or below 1280 × 1024 pixels. Confirm you have a continuous four-pair CAT5 run no longer than 135 metres between the two locations. This kit will not work for buyers who need higher resolutions, longer distances, HDMI or DisplayPort interfaces, or powered signal amplification.

Highlights

  • Extends VGA signals up to 135 metres over standard CAT5 cable
  • Passive design needs no external power supply
  • Includes both transmitter and receiver units in one package
  • Supports resolutions up to 1280 × 1024 pixels
  • Built-in sync controls keep the picture stable over long runs

Specifications

BrandBluecctv
ModelAP-TTP111VGA

Questions about this item

Which version of the Bluecctv AP-TTP111VGA should I choose for a 135 m run?

The single model AP-TTP111VGA is rated for up to 135 meters over 4-pair CAT5 STP or UTP cable and includes both transmitter and receiver units.

What does the 1280 × 1024 resolution mean when the extender is connected?

It supports VGA signals up to 1280 × 1024 pixels at the full 135 m distance without external power.

What interface does the extender use and what distance does it cap at?

It uses a VGA interface extended over standard 4-pair CAT5 STP or UTP cable, capped at 135 meters (400 ft).

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.