We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four silver brass tubes with 90-degree bends and straight sections

Bitspower

Bitspower Pre-bent 90-Degree Brass Hard Tubing OD12MM Silver 220x305mm 4pcs

SKU CH-X7MJ-7WX7N

Pre-bent 90-degree brass hard tubing with 220mm and 305mm straight sections, OD12mm silver finish, four pieces included

  • Pre-bent 90° angle saves installation time and skill
  • 12 mm OD brass tube fits standard water-cooling fittings
  • Silver finish resists corrosion and matches premium builds
  • 220 mm and 305 mm straight sections allow custom trimming
  • Four pieces included for multiple loop configurations

Ready-to-install brass tubing for custom loops

These four pre-bent brass tubes arrive with a 90-degree curve already formed, removing the trial-and-error of hand bending. Each piece offers straight sections of 220mm and 305mm on either side of the bend so you can trim to the exact run your loop demands. The silver finish matches common nickel-plated fittings for a uniform look. Novices and experienced builders alike save time during assembly.

Rigid brass construction with standard OD12MM fit

Brass resists kinking and holds its shape once cut, giving a clean, professional appearance inside the case. The outer diameter of 12mm fits the wide range of compression and push-fit fittings designed for this size. Pre-bent geometry means fewer joints and potential leak points compared to assembling multiple angled adapters. Cut ends deburr quickly with standard tubing tools before final installation.

Four-piece kit covers common 90-degree routing needs

The pack supplies exactly four identical pre-bent tubes, enough for typical CPU-to-radiator or GPU-to-distribution-plate turns. Builders planning more complex loops with additional 90-degree runs will need extra packs or straight tubing for custom bends. Verify that 220mm and 305mm straight sections suit your component spacing before purchase.

Highlights

  • Pre-bent 90° angle saves installation time and skill
  • 12 mm OD brass tube fits standard water-cooling fittings
  • Silver finish resists corrosion and matches premium builds
  • 220 mm and 305 mm straight sections allow custom trimming
  • Four pieces included for multiple loop configurations

Specifications

No published specifications for this item yet.

Questions about this item

What outer-diameter fittings does the 12 mm brass tubing accept?

The tubing is manufactured to a 12 mm outer diameter, so it fits standard 12 mm compression or push-fit fittings used in custom water-cooling loops.

How much straight tube remains on each side of the 90-degree bend for trimming?

Each piece provides 220 mm on one leg and 305 mm on the other leg of the bend, giving ample length to cut to the exact run required.

What is the correct way to cut and deburr the brass tube before inserting it into a fitting?

Use a tubing cutter designed for brass, rotate evenly to avoid flattening the 12 mm tube, then ream the inside and outside edges to remove burrs before final assembly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.