Bitspower BP-CLT16-90R Pre-bent 90° Acrylic Tubing 16mm OD 220x305mm 4 pcs

Pre-bent 90° acrylic tubing for custom loops

These four pre-bent 90-degree hard tubes have a 16 mm outer diameter and straight sections of 220 mm and 305 mm on each side of the bend. They are made for builders who want clean right-angle runs without heating and bending acrylic themselves. The pack suits both first-time loop builders and experienced users who value repeatable geometry.

Cut to length and push into 16 mm fittings

Installation is straightforward: measure the required run, cut the straight sections with a fine-tooth saw, chamfer the edges, then press the tube into standard 16 mm compression fittings. The most common issue is cutting too short or leaving rough edges that prevent a proper seal, so double-check measurements before sawing and deburr carefully.

Four right-angle pieces with 220 mm and 305 mm legs

Each tube provides a 90-degree turn with enough straight length on both sides to reach between typical component blocks and distribution plates. The fixed bend radius and leg lengths limit routing flexibility in very tight spaces or non-standard layouts, so verify your loop plan matches these dimensions before committing.