We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Bitspower

Bitspower BP-CLT14-90R 90° Acrylic Hard Tubing 14mm OD 220x305mm 4 pcs

SKU CH-ZWME-Y45YP MPN BP-CLT14-90R

Pre-bent 90-degree acrylic tubing with 14 mm outer diameter, 220 mm and 305 mm straight sections, four pieces for custom water-cooling loops

  • TypeTubing

Option 14 mm

  • Pre-bent 90-degree design eliminates complex tube bending
  • 14 mm outer diameter fits standard hard-tube fittings
  • 220 mm and 305 mm straight sections allow custom trimming
  • Acrylic construction provides rigid leak-resistant channels
  • Four-piece pack covers multiple 90-degree routing needs

Pre-bent 90° Acrylic Tubes 14mm OD

Four ready-made 90-degree acrylic hard tubes with 14mm outer diameter arrive pre-bent so no heating or bending tools are required. Each piece includes straight sections of 220mm and 305mm on either side of the curve. Builders can trim the straights to the exact length their loop demands.

Novice and experienced water-cooling builders

Suits anyone who wants clean right-angle runs without the trial-and-error of manual bending. Not for loops that need angles other than 90 degrees, custom radii, or tubing with a different outer diameter.

Four tubes with 220mm and 305mm straight legs

The 220mm and 305mm straight sections give ample room to reach most component spacing in a typical chassis. Very tight component stacks or unusually wide card clearances may leave insufficient straight length after trimming.

Highlights

  • Pre-bent 90-degree design eliminates complex tube bending
  • 14 mm outer diameter fits standard hard-tube fittings
  • 220 mm and 305 mm straight sections allow custom trimming
  • Acrylic construction provides rigid leak-resistant channels
  • Four-piece pack covers multiple 90-degree routing needs

Specifications

TypeTubing

Other versions of this model

2 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

What fittings do I need to connect these 14mm OD tubes?

You need 14mm OD compression fittings or push-fit connectors designed for rigid acrylic tubing; the 14mm outer diameter is the critical dimension for a leak-free seal.

Will these 90° pre-bent tubes align with standard G1/4 component ports?

Yes, the 90° bend with 220mm and 305mm straight legs fits typical component spacing; trim the legs to match your exact port-to-port distance.

How can I confirm the bend is leak-free after installation?

Pressure-test the loop with the pump running and inspect each 90° joint for drips; clear acrylic lets you see bubbles or moisture at the fitting seats immediately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.