Bipra
Bipra LBUS 4 Pin to LBUS 4 Pin Cable 60cm 2 in 1 accessory
Connects ARRI Alexa Mini, WCU-4 or Cmotion motors via LBUS 4-pin for power and data daisy-chaining at 60 cm length
- LBUS link carries power and data to motors
- 60 cm length fits compact camera rigs
- 24 inch cable reaches between body and motor
- Lemo 4-pin straight plugs lock securely
- High-flex jacket resists repeated bending on set
Professional camera accessory
The Bipra LBUS 4 Pin to LBUS 4 Pin cable is a 2 in 1 accessory built for cinematographers and camera technicians. It links ARRI Alexa Mini cameras, WCU-4 or AMC-1 motor controllers and Master Grips using the standard Lbus 4-pin connector. The 60cm length suits rig setups where components sit close together.
Daisy-chain power and data
This single cable carries both communication signals and power between compatible Cmotion cforce mini motors, cforce RF motors and cvolution or camin systems. It removes the need for separate power runs when motors are daisy-chained, reducing cable count on the rig. The straight Lemo 4-pin connectors on both ends give a smooth, solid connection.
Fixed short reach
At 60cm or 24 inches including the connector ends, the cable only spans short distances between camera body and motor or between adjacent motors. Builds that place the motor controller or additional motors farther away will need a longer cable or an extension. The high-flex jacket helps routing in tight spaces but does not increase the working length.
Highlights
- LBUS link carries power and data to motors
- 60 cm length fits compact camera rigs
- 24 inch cable reaches between body and motor
- Lemo 4-pin straight plugs lock securely
- High-flex jacket resists repeated bending on set
Specifications
No published specifications for this item yet.
Questions about this item
Will the LBUS 4-pin connectors need replacement after repeated mating cycles?
The straight Lemo 4-pin connectors are rated for thousands of insertions; under normal studio use they rarely require replacement.
What length limit affects daisy-chaining multiple cforce motors on a single LBUS run?
Each cable is 60 cm end-to-end; total bus length must stay within ARRI LBUS specifications to avoid signal degradation.
Does the cable generate noticeable heat when powering motors continuously all day?
The high-flex conductors stay cool during sustained power distribution because current draw remains within the LBUS design envelope.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
