We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pack of 25 SC single-mode OS2 connectors with ceramic ferrules

Bipra

Bipra 2 in 1 accessory SC UniCam High-Performance Single-mode OS2 Pack of 25

SKU CH-4HJZ-DMC9P

Pack of 25 SC UniCam single-mode OS2 connectors with factory-polished ceramic ferrules, .2 dB typical insertion loss and installation in about 50 seconds

  • Guaranteed 100 percent yield ensures every connector performs
  • Factory-polished ceramic ferrule delivers consistent optical performance
  • Typical 0.2 dB insertion loss optimises signal integrity
  • No-epoxy, no-polish design terminates in about 50 seconds
  • Operates from -40 °C to +75 °C for broad utility

SC UniCam OS2 connectors

This pack contains twenty-five Corning 95-200-41 UniCam High-Performance SC connectors for single-mode OS2 fibre. They are built for installers who need a fast, epoxy-free termination method in the field. Each connector uses a ceramic ferrule and is factory polished for consistent optical performance. The product is new and ready for immediate deployment.

Thermals and power

The connectors operate across a broad temperature range from minus forty Celsius to plus seventy-five Celsius, covering utility and outdoor environments. As passive components they draw no power and produce no noise during operation. Typical insertion loss is zero point two decibels with a maximum of zero point five decibels. Reflectance is rated at minus fifty-five decibels.

Build and daily use

The no-epoxy, no-polish design allows termination in about fifty seconds using the UniCam High-Performance Installation Tool Kit. FOCIS compliance with TIA/EIA 604-2 and IEC 61754-2 ensures interoperability with standard SC patching hardware. The pack of twenty-five suits projects requiring multiple terminations. Installers needing ST or LC interfaces will need a different connector type.

Highlights

  • Guaranteed 100 percent yield ensures every connector performs
  • Factory-polished ceramic ferrule delivers consistent optical performance
  • Typical 0.2 dB insertion loss optimises signal integrity
  • No-epoxy, no-polish design terminates in about 50 seconds
  • Operates from -40 °C to +75 °C for broad utility

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the SC UniCam connector, and what step do people get wrong?

The connector uses a no-epoxy, no-polish design and terminates in about 50 seconds with the UniCam High-Performance Installation Tool Kit; the step often missed is using the correct tool kit rather than standard cleaving tools.

What maintenance or replacement will the SC UniCam connector need later?

Factory-polished end faces and ceramic ferrules require no scheduled maintenance; replacement is only needed if the ferrule is physically damaged or if insertion loss exceeds the 0.5 dB maximum specification.

What limit shows up first under sustained use of the SC UniCam connector?

The operating temperature range spans -40 °C to +75 °C; sustained exposure beyond these limits will degrade optical performance before any mechanical wear appears.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.