Binks
Binks 29-249 Spray Booth Coating White 5 gal
Water-based white spray booth coating covers 525 to 875 square feet per gallon and dries in one to two hours
- ColorWhite
- Water-based formula simplifies cleanup
- White flat finish brightens booth walls
- Spray application covers 525 to 875 sq ft
- Dries in 1 to 2 hours for quick turnaround
- Apply at 60 to 70 F for proper curing
Product Identity
Binks 29-249 Spray Booth Coating is a water-based, white latex finish supplied in a five-gallon container for spray application on metal and plastic surfaces. It dries flat within one to two hours at recommended temperatures.
Suitable Users
This coating suits maintenance teams and booth operators who need a quick-drying, water-based white layer applied by spray gun in controlled environments between 60 and 70 degrees Fahrenheit. Buyers requiring solvent-based chemistry, tinted colours, or brush and roller application methods should look at alternative products.
Coverage and Limits
One five-gallon unit covers approximately 525 to 875 square feet depending on substrate porosity and spray technique, providing ample material for standard booth refresh cycles. Coverage drops toward the lower end on rough or absorbent surfaces, and the product is not formulated for immersion service or high-heat zones beyond the stated application range.
Highlights
- Water-based formula simplifies cleanup
- White flat finish brightens booth walls
- Spray application covers 525 to 875 sq ft
- Dries in 1 to 2 hours for quick turnaround
- Apply at 60 to 70 F for proper curing
Specifications
| Brand | BINKS |
|---|---|
| Color | White |
Questions about this item
Do I need a spray system that can handle water-based latex at the 60 to 70 F application range?
Yes, the coating is water-based latex and the manufacturer specifies an application temperature of 60 to 70 F, so your spray equipment must operate reliably in that range.
Can I apply this over existing booth surfaces that were coated with a different product?
The coating is designed for metal and plastic booth surfaces; adhesion to other coatings is not addressed in the specifications, so a test patch is recommended.
How can I confirm the coating is performing as intended after spraying?
Check for a flat white finish, coverage within the 525 to 875 range, and dry-to-touch time of 1 to 2 hours under the recommended temperature.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
