We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Weighted metal microphone boom arm with desk clamp and hidden cable channel

BFKK

BFKK Mic Stand Boom Arm Weighted Metal 360° Rotation 1.6kg

SKU CH-B3K4-R98ZR

A weighted metal boom arm holds microphones up to 1.6 kg with 180° to 360° pivot adjustment and hidden cable management

  • Supports mics up to 3.5lb (1.6kg) with all-metal tube construction
  • Silent movement via internal spring design prevents noise during adjustments
  • Five pivot points adjust 180° to 360° for precise microphone positioning
  • Hidden cable channel routes XLR or USB cables cleanly off the desk
  • Wide clamp with silicone pad protects surfaces and resists shaking

Mic stand for 1.6 kg microphones

The BFKK boom arm uses an all-metal tube construction rated for microphones up to 1.6 kg (3.5 lb). A standard 3/8" to 5/8" adapter fits HyperX QuadCast, Blue Yeti, Shure MV7, Rode and similar models. The desk clamp includes a silicone cushion and a wide contact area to protect surfaces and resist wobble. A hidden cable channel routes USB or XLR leads out of sight.

Silent adjustment with five pivots

Internal weighted joints replace exposed springs, so repositioning produces no mechanical noise during recording. Five pivot points offer an adjustable angle range from 180° to 360°, letting you place the capsule exactly where you need it. Tightness at each joint is adjustable to prevent unwanted drift over time. The design suits podcasting, streaming and voice-over work where quiet operation matters.

Steady under continuous repositioning

The weighted metal arms counterbalance the microphone, keeping it stable during long sessions and frequent angle changes. Adjustable joint tension maintains the chosen position without sag, even after repeated movement. The clamp's broad footprint and silicone pad keep the base fixed to the desk through daily use. Cable management stays tidy inside the channel regardless of how often the arm is swung.

Highlights

  • Supports mics up to 3.5lb (1.6kg) with all-metal tube construction
  • Silent movement via internal spring design prevents noise during adjustments
  • Five pivot points adjust 180° to 360° for precise microphone positioning
  • Hidden cable channel routes XLR or USB cables cleanly off the desk
  • Wide clamp with silicone pad protects surfaces and resists shaking

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the boom arm on my desk and what step is often missed?

Clamp the base to a desk edge using the silicone-cushioned clamp, then insert the 3/8" to 5/8" adapter into the microphone's thread before mounting the mic; the adapter step is the one most people forget.

What maintenance or replacement will this stand need over time?

Periodically check and tighten the five pivot-point adjustment knobs to maintain position holding; no internal springs or gas struts require replacement.

What limit appears first during long recording sessions?

The 1.6 kg (3.5 lb) load capacity is the hard limit; exceeding it will cause the arm to sag regardless of how tight the pivots are set.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.