BFKK
BFKK Dual Band WiFi Bluetooth Antenna 2.4 5.8 GHz 3dBi RP-SMA Male No Pin 2 Pack
Dual-band 2.4 and 5.8 GHz antennas with 3 dBi gain and RP-SMA male no-pin connectors, two per pack
- Dual-band 2.4 GHz and 5.8 GHz coverage extends Wi-Fi and Bluetooth range
- 3 dBi gain boosts signal strength for faster, more stable connections
- RP-SMA male no-pin connector fits motherboards, routers and Mini PCIe M.2 cards
- Adjustable swivel design lets you angle each antenna for optimal reception
- Two antennas in the pack provide spare or simultaneous upgrade for multiple devices
Dual-band 2.4 / 5.8 GHz antenna pair
This two-pack supplies RP-SMA male antennas that operate across 2400-2500 MHz and 5150-5850 MHz with 3 dBi gain. They are built for desktop PCs, Mini PCIe or M.2 wireless cards, routers and compatible receivers that need stronger Wi-Fi and Bluetooth coverage.
RP-SMA male no-pin connector with swivel base
Each antenna screws directly onto an RP-SMA female port and can be angled or swivelled to optimise signal direction. The no-pin centre conductor means the mating jack must also be pinless, so verifying the device connector before fitting avoids a mechanical mismatch.
Replaces stock whip antennas on compatible gear
The pair upgrades the short fixed antennas shipped with many motherboards, PCIe cards or routers when greater range or steadier throughput is needed. The improvement is only worthwhile if the host device already uses RP-SMA female no-pin jacks and operates on the stated 2.4 GHz and 5.8 GHz bands.
Highlights
- Dual-band 2.4 GHz and 5.8 GHz coverage extends Wi-Fi and Bluetooth range
- 3 dBi gain boosts signal strength for faster, more stable connections
- RP-SMA male no-pin connector fits motherboards, routers and Mini PCIe M.2 cards
- Adjustable swivel design lets you angle each antenna for optimal reception
- Two antennas in the pack provide spare or simultaneous upgrade for multiple devices
Specifications
No published specifications for this item yet.
Questions about this item
Does the RP-SMA male connector limit the antenna to 2.4 GHz or 5.8 GHz bands?
The antenna covers both 2400-2500 MHz and 5150-5850 MHz ranges, so the connector does not restrict either band.
What female connector must the motherboard or card provide for these antennas to attach?
The device needs an RP-SMA female jack; the antennas have RP-SMA male plugs with no centre pin.
What is the correct way to tighten the antennas, and what mistake damages the threads?
Screw each antenna onto the RP-SMA female connector by hand until snug, then adjust the swivel angle; over-tightening with tools strips the threads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
