We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Twenty-four black Cat6 patch cables with gold connectors and strain relief clips

BFKK

BFKK Cat6 0.5ft 24-pack network ethernet cable

SKU CH-H661-QMET8

Pack of 24 short Cat6 patch cables, each .5 ft long with gold-plated contacts for 10 Gbps at 550 MHz

  • Pre-made cables eliminate hours of cutting and crimping
  • Gold-plated 8P8C contacts support 10G speeds at 550MHz
  • 5ft length keeps patch-panel runs tidy and uniform
  • Moulded strain relief and clip protector simplify unplugging
  • Meets or exceeds TIA/EIA 568-C.2 Category 6 standard

Ready-to-use 0.5 ft Cat6 cables

This 24-pack of pre-made Cat6 patch cables eliminates the time and effort of cutting and crimping custom lengths for patch panels. Each cable is 0.5 ft long and built with 26AWG stranded pure copper conductors. Gold-plated 8P8C contacts support up to 10G speed at 550 MHz. The fully moulded strain relief and easy-unplug clip protector add durability for repeated changes.

Replaces hand-made patch cords

Installers upgrading from hand-crimped Cat5 or Cat5e runs gain reliable 10G performance that meets or exceeds the TIA/EIA 568-C.2 standard. The jump is worth it when rack density demands consistent short lengths and colour-matched cables for clean wire management. Pre-terminated ends remove the variability of field termination and reduce troubleshooting time.

Twenty-four cables for dense patching

The pack provides enough 0.5 ft cords to populate a full patch panel to switch interconnect with uniform cable management. Each strand handles 10G Ethernet up to 550 MHz, so headroom is adequate for gigabit and 10-gigabit backbone links. Runs longer than the supplied length or installations requiring shielded or outdoor-rated jackets fall outside this kit's scope.

Highlights

  • Pre-made cables eliminate hours of cutting and crimping
  • Gold-plated 8P8C contacts support 10G speeds at 550MHz
  • 5ft length keeps patch-panel runs tidy and uniform
  • Moulded strain relief and clip protector simplify unplugging
  • Meets or exceeds TIA/EIA 568-C.2 Category 6 standard

Specifications

No published specifications for this item yet.

Questions about this item

How much rack space does each 0.5ft cable need for patch-panel-to-switch runs?

Each cable measures 0.5ft, so 24 cables occupy minimal vertical space and keep patch-panel-to-switch links tidy in a standard 1U panel.

What is the correct way to seat the 8P8C connectors on a patch panel, and what step do installers often skip?

Push each gold-plated 8P8C plug until the latch clicks; the step often skipped is verifying the click on both sides to ensure full contact at 550MHz.

When should the 26AWG stranded copper cables be replaced in a 10G environment?

Replace any cable that shows jacket damage, bent latches, or intermittent link errors on 10G ports; the stranded 26AWG conductors resist fatigue but are not field-repairable.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Network Ethernet Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.