BFKK
BFKK 14 Pack Double Bullseye Marker Lights IP67 rv lighting
Fourteen double bullseye marker lights with twelve LEDs each and IP67 waterproof rating
- 12 LEDs per light for bright visibility
- IP67 waterproof rating resists dust and water
- 14-pack covers multiple trailer positions
- Surface-mount design for quick installation
- Reflector lens boosts light output
14-Pack LED Marker Lights for Trailers
This 14-pack supplies double bullseye LED marker lights rated IP67 for waterproof and dustproof protection. Each unit contains 12 super-bright LEDs behind a coloured polycarbonate housing and acrylic lens. The surface-mount design allows a straightforward upgrade on RVs, campers, cargo trailers, utility trailers and boat trailers. The lights operate on 12V systems for broad compatibility.
Suits Multi-Vehicle Fleets Not Single Axles
The 14-light quantity covers both sides of multiple trailers or a full fleet refresh in one purchase. Buyers needing only a pair for a single-axle utility trailer will find the pack excessive. The surface-mount format requires a flat mounting surface, so it does not suit recessed or grommet-style cut-outs. Vehicles without a 12V electrical system cannot use these lights.
IP67 Waterproof Rating Decides Fit
The IP67 rating confirms each light withstands immersion and dust ingress, making it the deciding factor for marine and harsh-weather use. If the installation area stays dry and sheltered, a lower-rated light would also function. The snap-on reflector lens uses a mirrored principle to boost output without extra power draw. This single spec determines whether the lights survive the intended environment.
Highlights
- 12 LEDs per light for bright visibility
- IP67 waterproof rating resists dust and water
- 14-pack covers multiple trailer positions
- Surface-mount design for quick installation
- Reflector lens boosts light output
Specifications
No published specifications for this item yet.
Questions about this item
What surface area do the 2" x 4" marker lights need for mounting?
Each light measures two inches by four inches and mounts on any flat surface with that clearance.
How do the snap-on reflector lenses attach during installation?
The lenses snap directly onto the housing after the base is secured; the step often missed is pressing until the clips click.
When do the 12 LEDs inside each sealed unit need replacement?
The IP67 housing is not serviceable; the whole marker light is replaced when output fades.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



