We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four 20-inch UV LED strips in clear waterproof tubes with red and black wires

BFKK

BFKK 12V UV LED Light Strip 4 Pcs 20 Inch IP67 5050

SKU CH-NHQ6-WB4EF

Four 20-inch strips each pack 30 SMD 5050 chips in IP67 silicone tubes for 12 V marine use

  • Four strips each 20 inches long with 30 SMD5050 chips per strip
  • IP67 silicone tube protects against water and dust in harsh marine conditions
  • 3M VHB adhesive backing allows quick peel-and-stick mounting on clean dry surfaces
  • Simple two-wire 12 V connection with red positive and black negative leads
  • UV black-light output designed for night fishing on pontoon, kayak, yacht or sailboat

UV LED Strip Kit

Four twenty-inch strips run on twelve-volt power and each carries thirty 5050 chips rated IP67 for marine use. The ultra-violet output suits night fishing, pontoon decks, kayaks and yacht interiors where water exposure is constant.

Thermals and Power

The low-voltage design keeps heat minimal during normal operation and the silicone tube dissipates warmth without active cooling. Current draw stays low so the strips add negligible load to a boat's twelve-volt system.

Mounting and Wiring

Pre-applied 3M VHB tape bonds to clean dry surfaces after an alcohol wipe and the two-wire harness uses red for positive and black for negative. Polarity must be verified before permanent installation to avoid damage.

Highlights

  • Four strips each 20 inches long with 30 SMD5050 chips per strip
  • IP67 silicone tube protects against water and dust in harsh marine conditions
  • 3M VHB adhesive backing allows quick peel-and-stick mounting on clean dry surfaces
  • Simple two-wire 12 V connection with red positive and black negative leads
  • UV black-light output designed for night fishing on pontoon, kayak, yacht or sailboat

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 12V UV LED strips and which wiring step causes the most problems?

Clean the mounting surface with alcohol, let it dry, then peel the 3M VHB backing and press the strip in place. Connect the red wire to positive and the black wire to negative; reversing the polarity is the step that stops the lights from working.

What maintenance or replacement will the 5050 LED strips need over time?

The IP67 silicone tube can be wiped clean with a damp cloth. The 30 LEDs per strip are not user-replaceable, so the whole 20-inch unit is swapped if output drops or a section fails.

What limit appears first when the 4-piece UV kit runs continuously on a boat?

The 12-volt supply and the adhesive bond are the first limits; voltage drop on long wire runs dims the 5050 chips, and heat or salt exposure can weaken the 3M VHB tape before the LEDs themselves degrade.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.