We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red and black thick power cables coiled with fuse holder

BESIGN

BESIGN SoundBox KIT0-25RB 0 Gauge Amplifier Cable 50 Ft Pro Sound

SKU CH-BQQH-JBN0D

Red and black 1/0 gauge CCA power and ground cable kit with 250 A ANL fuse holder, 50 ft total length

  • 50 ft total CCA cable for extended amplifier runs
  • 25 ft red plus 25 ft black for clear power and ground separation
  • UltraFlex heat-tested jacket resists high engine-bay temperatures
  • 250 A ANL fuse holder protects the system from over-current
  • International wire-gauge standard ensures consistent conductor sizing

0 Gauge Amplifier Cable Kit

The BESIGN SoundBox KIT0-25RB supplies 25 feet of red and 25 feet of black 1/0 gauge power and ground cable. It includes a Pro Series ANL fuse holder fitted with a 250 AMP fuse. The wire uses copper clad aluminium and meets international gauge standards.

Check Your Installation Requirements

Verify that your amplifier and battery terminals accept 1/0 gauge conductors and ANL fuse holders. Ensure you have a clear route for two separate 25 foot runs from the power source to the amplifier location. Confirm the copper clad aluminium construction suits your current draw expectations.

Sustained Load Behaviour

The UltraFlex heat tested jacket is designed to resist degradation during continuous high current flow. Copper clad aluminium carries lower conductivity than solid copper, so voltage drop increases over the full 50 foot length under steady demand. The 250 AMP fuse protects the wire from prolonged overload conditions.

Highlights

  • 50 ft total CCA cable for extended amplifier runs
  • 25 ft red plus 25 ft black for clear power and ground separation
  • UltraFlex heat-tested jacket resists high engine-bay temperatures
  • 250 A ANL fuse holder protects the system from over-current
  • International wire-gauge standard ensures consistent conductor sizing

Specifications

No published specifications for this item yet.

Questions about this item

What comes in the box and what must I buy separately?

The kit includes 25 feet of red 1/0 gauge cable, 25 feet of black 1/0 gauge cable, and a Pro Series 0 gauge ANL fuse holder with a 250 AMP ANL fuse. Connectors, terminals, or distribution blocks are not included and must be purchased separately.

Which cable version should I choose for my amplifier install?

This single kit provides 50 total feet of Copper Clad Aluminum wire split into equal 25-foot red and black rolls for power and ground runs. There are no alternative gauge or length versions of this specific KIT0-25RB package to select from.

How does the 250 AMP ANL fuse rating work once installed in my vehicle?

The included ANL fuse holder and 250 AMP fuse protect the main power wire between the battery and amplifier. The fuse will blow if current exceeds 250 amps, preventing the 1/0 gauge CCA cable from overheating during a short circuit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.