We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black toggle switch with PVC coating and two wire leads

BEP MARINE

BEP MARINE SPST Water-Resistant Toggle Switch OFF/ON 12V 25A

SKU CH-ZSWD-M9HRG

Single-pole toggle switch controls one 12 V circuit at 25 A with PVC-coated water resistance and 8-inch 16 AWG leads

  • Single-pole switch controls one circuit reliably
  • 12 V DC rating handles marine electrical loads
  • 25 A capacity supports high-draw accessories
  • 16 AWG PVC leads resist water ingress
  • 15/32" stem mounts in panels up to 3/16" thick

Single-Circuit On/Off Control

This BEP Marine SPST toggle switch provides a simple on-off function for one electrical circuit. It is built for 12 V DC systems in marine, RV or automotive environments where reliable switching is needed.

25 A Rating and 16 AWG Leads

The switch handles up to 25 A at 12 V DC, suitable for lighting, pumps or accessory circuits within that limit. It ships with 8-inch 16 AWG wire leads for direct connection, while the 15/32-inch mounting stem fits panels up to 3/16-inch thick.

PVC-Coated Water Resistance

A PVC coating seals the toggle mechanism against moisture and spray encountered in open-cockpit or bilge areas. The coating adds no active cooling requirement and draws no power itself, leaving the full 25 A capacity available to the load.

Highlights

  • Single-pole switch controls one circuit reliably
  • 12 V DC rating handles marine electrical loads
  • 25 A capacity supports high-draw accessories
  • 16 AWG PVC leads resist water ingress
  • 15/32" stem mounts in panels up to 3/16" thick

Specifications

BrandBEP Marine

Questions about this item

Will the 15/32" mounting stem fit the same panel cut-out as my existing Cole Hersee 5582-30 switch?

Yes, the stem dimensions match the Cole Hersee 5582-30, so it fits panels up to 3/16" thick using the same hole size.

How can I verify the switch is operating correctly at its 25A 12V DC rating after installation?

Apply 12V DC to the 16 AWG leads and measure current flow; the toggle should cleanly make and break the circuit without excessive heat at the rated load.

Does the box include mounting hardware or only the switch with its 8" 16 AWG wire leads?

The switch ships with the PVC-coated body, toggle actuator, 8" 16 AWG wire leads and mounting stem; panel nuts or washers are not included.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.