BenQ
BenQ MX662 OEM Osram P-VIP 240W Projector Lamp 2500 Hrs
A replacement lamp module with a 240W Osram P-VIP bulb and housing delivers 2,500 hours of projection time for the BenQ MX662
- TypeProjector Lamp
- Wattage240W
- Lamp Life2,500 Hrs.
- Ready-to-install module saves setup time
- OEM Osram P-VIP 240W bulb matches original brightness
- 2,500-hour lamp life extends replacement intervals
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition, voltage and run-time
Direct Replacement Lamp Module
The BenQ MX662 lamp module arrives as a fully assembled 240 W bulb and housing ready for installation in compatible BenQ projectors. It uses an Osram P-VIP light source rated for 2 500 hours of operation. The unit is supplied new and meets ISO 9001 manufacturing standards.
Steady Light Output Over Rated Life
Under continuous operation the lamp maintains consistent brightness for the full 2 500 hour rating rather than fading quickly after an initial burst. Each unit is tested for ignition reliability voltage stability and run time before shipment. The OEM sourced bulb is designed to match the projector original light engine specifications.
Thermal Behaviour and Power Draw
The 240 W power rating defines the heat load the projector cooling system must handle during normal use. Because the module replicates the original lamp thermal profile the existing fan curve and airflow paths remain adequate. No additional ventilation or power supply changes are required for standard operation.
Highlights
- Ready-to-install module saves setup time
- OEM Osram P-VIP 240W bulb matches original brightness
- 2,500-hour lamp life extends replacement intervals
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition, voltage and run-time
Specifications
| Brand | BenQ |
|---|---|
| Type | Projector Lamp |
| Wattage | 240W |
| Lamp Life | 2,500 Hrs. |
Questions about this item
How much power does the 240W Osram P-VIP lamp draw during continuous use?
The lamp is rated at 240W, so the projector will draw that amount while the lamp is lit. Actual system power will be slightly higher due to the projector’s own electronics and cooling fans.
Does the MX662 module arrive with the bulb already seated in the housing so I only need the projector?
Yes, the unit ships as a complete assembly with the new Osram P-VIP 240W bulb pre-installed in the housing, ready to fit directly into a compatible BenQ projector.
Will this 5J.J6E05.001 lamp work in my older BenQ projector that originally used a lower-wattage module?
The MX662 lamp is designed for specific BenQ models that accept the 240W P-VIP module; using it in a projector built for a different wattage or form factor can cause fit or thermal issues.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



