We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue bulk Ethernet cable on wooden spool, 1000ft Cat6 UTP solid copper wire

Belkin

Belkin Cat6 1000ft Bulk Network Ethernet Cable A7L704-1000-BLU

SKU CH-2JWF-8H91S

Bulk Cat6 cable with 4-pair 23 AWG solid conductors and separator for Gigabit Ethernet runs

  • Supports Gigabit Ethernet with Category 6 compliance
  • 1000 ft length covers large installations in one run
  • 23 AWG solid conductors reduce signal loss over distance
  • Built-in pair separator minimises crosstalk between channels
  • Unshielded twisted-pair design simplifies termination and routing

1000ft Cat6 Bulk Cable

This Belkin Cat6 bulk cable supplies 1000 feet of unshielded twisted-pair wiring for structured cabling projects. It is made for installers and network builders who terminate their own runs in commercial or residential settings. The 4-pair construction supports Gigabit Ethernet and higher speeds where the infrastructure demands it. It arrives as a single continuous length on a pull box for easy handling.

Thermals Noise Power

As a passive copper cable it generates no heat, emits no noise and draws no power during operation. Performance depends entirely on the quality of termination and the active equipment at each end. There are no fans, power supplies or active components to manage. Thermal and acoustic considerations apply only to the connected switches or patch panels.

Build Connectors Mounting

The cable uses 23 AWG solid conductors with a pair separator to maintain Category 6 geometry and meets EIA/TIA-568 Category 6 requirements. Both ends are bare wire, so every drop requires punch-down or modular plug termination on site. The blue jacket aids visual identification in dense cable trays or conduit runs. The pull-box packaging protects the reel during transport and allows straight pulls without kinking.

Highlights

  • Supports Gigabit Ethernet with Category 6 compliance
  • 1000 ft length covers large installations in one run
  • 23 AWG solid conductors reduce signal loss over distance
  • Built-in pair separator minimises crosstalk between channels
  • Unshielded twisted-pair design simplifies termination and routing

Specifications

No published specifications for this item yet.

Questions about this item

How do I pull and terminate this 1000 ft Cat6 bulk cable, and what step causes most failures?

Pull the 23 AWG solid conductors gently to avoid kinking, keep the pair separator intact, and terminate each 4‑pair run within the EIA/TIA‑568 Category 6 length limit; the most common error is untwisting pairs too far back at the jack.

What maintenance or replacement will this bare‑wire Cat6 cable need after installation?

The solid 23 AWG UTP construction requires no scheduled maintenance; replace only if a segment is crushed, kinked, or fails a certification test.

What distance limit appears first when running this cable at Gigabit speeds?

The EIA/TIA‑568 Category 6 channel limit of 100 m governs maximum segment length for 1000Base‑T operation.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.