We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black steel pipe nipple with threaded ends, twelve inches long

Beck C. H.

Beck C. H. Pipe Nipple Steel 2 1/2 in NPT 12 in

SKU CH-J8GW-29KEY

Steel pipe nipple with NPT threads on both ends for air, gas, oil and non-potable water up to 300 psi

  • ColorTransparent
  • Built for air, gases, non-potable water and oils
  • Black anodized finish resists corrosion in harsh environments
  • Welded steel construction rated to 300 psi at 150 °F
  • Handles steam up to 150 psi at 360 °F
  • Made in USA with Grade B steel

Pipe Nipple for Air Gases Oils

This steel pipe nipple handles air gases non-potable water and oils at up to 300 psi and 150 degrees F. The welded Grade B steel construction carries a black anodized finish and a 12 inch length with NPT threads on both ends. It suits industrial piping runs where steam pressure may reach 150 psi at 360 degrees F.

Thermals Noise and Power Draw

The passive metal body produces no noise and draws no power during normal operation. Heat dissipation relies on the surrounding fluid and ambient conditions rather than active cooling. Maximum operating limits are 300 psi at 150 degrees F for general fluids and 150 psi at 360 degrees F for steam service.

Black Anodized Finish and USA Build

The black anodized coating adds surface protection against corrosion in air gas oil and non-potable water lines. Manufacture in the USA ensures consistent Grade B steel quality and welded joint integrity. No extra gaskets software or fittings are bundled so installers supply their own sealing method.

Highlights

  • Built for air, gases, non-potable water and oils
  • Black anodized finish resists corrosion in harsh environments
  • Welded steel construction rated to 300 psi at 150 °F
  • Handles steam up to 150 psi at 360 °F
  • Made in USA with Grade B steel

Specifications

ColorTransparent
BrandBECK

Questions about this item

How do I install the 2 1/2 in NPT steel pipe nipple without damaging the threads?

Apply PTFE tape or pipe dope to the NPT threads, then hand-tighten before using a strap wrench on the 12 in body to avoid crushing the welded steel wall.

What maintenance does the black anodized finish on this Grade B steel nipple require over time?

Inspect the anodized coating annually for chips or corrosion; re-coat or replace the nipple if the 300 psi pressure boundary is compromised.

At what temperature does the 150 psi steam rating become the limiting factor during continuous operation?

The 150 psi steam limit applies at 360 Degrees F, which is reached before the 300 psi air or oil rating at 150 Degrees F.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.