We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanized steel pipe nipple, 2 inch MNPT by 7 inch TBE, Schedule 40, welded construction, silver-grey finish

Beck C. H.

Beck C. H. 2" MNPT x 7" TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-0AC6-YSW9Q

Galvanised steel pipe nipple with 2" MNPT threads and 7" length for air, gas, oil and non-potable water at 150 psi

  • MaterialHAWA
  • Galvanized coating resists corrosion on air, gas, oil and non-potable water lines
  • Schedule 40 welded steel construction rated for 150 psi at 150 °F
  • 2-inch NPT male threads on both ends fit standard 2-inch pipe fittings
  • 7-inch overall length suits tight plumbing runs and equipment connections
  • Made in USA from Grade B steel for consistent wall thickness and strength

Galvanized Steel Pipe Nipple

This galvanized steel pipe nipple is a Schedule 40 fitting designed for air, gases, non-potable water and oil lines. It features a 2-inch nominal pipe size with male NPT threads on one end and threaded both ends for standard connections. The welded construction uses Grade B steel made in the USA with a galvanized finish for corrosion resistance.

Installers needing a 2-inch threaded connector

Plumbers and maintenance technicians joining 2-inch steel pipe runs in compatible fluid systems will find this nipple fits the requirement. The 150 psi pressure rating at 150 degrees Fahrenheit covers many low-pressure applications. Systems requiring higher steam pressure ratings or different material grades should evaluate alternative fittings.

2-inch nominal pipe size with MNPT x TBE threading

The nominal pipe size of 2 inches defines compatibility with matching Schedule 40 pipe and fittings. One end provides a male NPT thread while the other end is threaded both ends, determining how this nipple integrates into an existing pipeline. Verify the thread configuration matches the installation plan before purchase.

Highlights

  • Galvanized coating resists corrosion on air, gas, oil and non-potable water lines
  • Schedule 40 welded steel construction rated for 150 psi at 150 °F
  • 2-inch NPT male threads on both ends fit standard 2-inch pipe fittings
  • 7-inch overall length suits tight plumbing runs and equipment connections
  • Made in USA from Grade B steel for consistent wall thickness and strength

Specifications

MaterialHAWA
BrandBECK

Questions about this item

How do I install the 2" MNPT threads on this galvanized steel nipple without leaks?

Apply PTFE tape or pipe dope to the male NPT threads, tighten two turns past hand-tight with a pipe wrench, and avoid over-torquing which can crack the galvanized coating.

What maintenance does the galvanized coating on this Schedule 40 nipple require over time?

Inspect the galvanized finish annually for white rust or scaling; replace the nipple if the coating is breached and bare steel is exposed to the fluid.

At what pressure does the 150 psi rating become the limiting factor during sustained use?

The 150 psi maximum operating pressure at 150 °F is the first limit reached; sustained pressure above this value risks joint failure on the welded Schedule 40 wall.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.