We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short galvanized steel pipe nipple with threaded ends

Beck C. H.

Beck C. H. 2" MNPT x 3" TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-1NQ8-3AH1X

Connects 2-inch NPT threads for air, gas, oil, steam or water service at 150 psi

  • MaterialHAWA
  • Galvanized coating protects against corrosion in wet systems
  • Schedule 40 wall handles 150 psi at 150 °F
  • Male NPT threads connect directly to female fittings
  • Welded steel construction resists vibration and pressure cycling
  • Made in USA from Grade A steel

2 in Schedule 40 galvanized steel nipple

This 2 in nominal pipe size nipple is made from Grade A steel with a continuous weld and galvanized coating. It suits air, gas, oil, steam and water lines in industrial and commercial plumbing. The male NPT threads on one end and TBE preparation on the other allow direct connection to Schedule 40 fittings. Builders needing a different nominal size or pressure class should select another product.

Thermals noise and power draw in normal use

The galvanized finish resists corrosion from steam and water exposure at the rated temperature. With a maximum operating pressure of 150 psi at 150 Degrees F the nipple maintains seal integrity without deformation. No moving parts or electrical components mean zero noise and no power consumption during operation. Installations requiring higher pressure ratings must use a different schedule.

Bundled accessories and software impact

The nipple is supplied as a single fitting with no gaskets, sealant or installation tools included. Thread sealant or tape must be sourced separately to match the service fluid. No software or digital configuration applies to this mechanical component. Projects needing pre-applied coatings or assembled assemblies will require additional procurement.

Highlights

  • Galvanized coating protects against corrosion in wet systems
  • Schedule 40 wall handles 150 psi at 150 °F
  • Male NPT threads connect directly to female fittings
  • Welded steel construction resists vibration and pressure cycling
  • Made in USA from Grade A steel

Specifications

MaterialHAWA
BrandBECK

Questions about this item

How do I install a 2 in NPT threaded nipple and what step is often missed?

Wrap PTFE tape or pipe dope on the male threads, screw into the female fitting, and tighten two full turns past hand-tight; the step often missed is cleaning both thread sets first so sealant bonds.

What maintenance or replacement will a galvanized Schedule 40 nipple need over time?

Inspect for white zinc corrosion or rust at the threads; replace the nipple if the coating is breached or if leaks appear at the joint.

What limit appears first when this nipple runs continuously at 150 psi and 150 °F?

The 150 psi @ 150 °F rating is the design ceiling; sustained operation at that pressure and temperature leaves no safety margin, so pressure creep or thermal cycling will cause leaks first.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.