We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
12-inch galvanized steel pipe nipple with male threaded ends

Beck C. H.

Beck C. H. 2-1/2" MNPT x 12" TBE Galvanized Steel Pipe Nipple Sch 40 equipment

SKU CH-7M4K-4K1VC

A galvanized steel pipe nipple with male NPT threads, Schedule 40 rating and 150 psi maximum pressure for air, gas, oil, steam or water systems

  • MaterialHAWA
  • Weight5.06
  • Galvanized coating resists corrosion for air, gas, oil, steam and water service
  • Schedule 40 wall handles 150 psi at 150 °F continuous operation
  • 12 inch overall length with 2 1/2 inch NPT male threads on both ends
  • Continuous welded Grade A steel construction made in the USA
  • Weighs 5.06 lbs for secure handling and installation

Industrial pipe nipple for air gas oil steam water

This 12 inch galvanized steel nipple connects threaded components in Schedule 40 piping systems. The welded construction handles 150 psi at 150 degrees Fahrenheit. It suits industrial plumbing installations that require a male NPT thread on one end.

Galvanized coating resists corrosion in wet

The zinc finish protects the steel substrate when the line carries water or steam. Continuous weld seams maintain structural integrity under the rated pressure. The coating eliminates the need for additional thread sealant against rust.

Male NPT threads mate

The 2 1/2 inch nominal bore matches common industrial pipe dimensions. A 2 7/8 inch outside diameter fits typical couplings and valves. Made in USA Grade A steel weighs 5.06 units for secure handling during assembly.

Highlights

  • Galvanized coating resists corrosion for air, gas, oil, steam and water service
  • Schedule 40 wall handles 150 psi at 150 °F continuous operation
  • 12 inch overall length with 2 1/2 inch NPT male threads on both ends
  • Continuous welded Grade A steel construction made in the USA
  • Weighs 5.06 lbs for secure handling and installation

Specifications

MaterialHAWA
Weight5.06
BrandBECK

Questions about this item

Will the galvanized coating on the 2-1/2 inch Schedule 40 nipple need replacement if used for water supply?

The galvanized finish protects the steel from corrosion in water, air, gas, oil and steam applications. Under normal conditions the coating lasts for years; inspect threads and surface periodically for white rust or flaking.

What pressure limit applies first when the nipple runs continuously at 150 degrees Fahrenheit?

The maximum operating pressure is 150 psi at 150 degrees Fahrenheit. Sustained use at that temperature should not exceed this rating; higher temperatures would lower the allowable pressure further.

How much heat does the steel nipple radiate when carrying 150-degree steam all day?

The welded Schedule 40 steel wall conducts heat from the fluid to the surroundings. Surface temperature will approach the internal 150 degrees Fahrenheit, so insulation is recommended for personnel protection and energy efficiency.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.