We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
10 inch galvanized steel pipe nipple threaded both ends

Beck C. H.

Beck C. H. 1" MNPT x 10" TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-W3PP-59CB1

Threaded galvanized steel pipe nipple, Schedule 40, rated 150 psi at 150 °F with 1.049 in inside diameter

  • Reliable corrosion resistance from galvanized steel construction
  • Leak-tight joints with MNPT threads on both ends
  • Handles 150 psi at 150 °F for demanding systems
  • Schedule 40 wall thickness of .133 in adds strength
  • Meets ASTM A-53 Type F and ASTM A733 Grade A standards

1" Galvanized Steel Pipe Nipple

This 1-inch nominal Schedule 40 nipple is made from continuously welded galvanized steel. It measures 10 inches overall with 1.049-inch inside diameter and 1.315-inch outside diameter. Threaded MNPT on both ends, it suits water, air or gas lines up to 150 psi at 150 degrees F.

Installers needing a 10-inch threaded connector

Plumbers and maintenance crews joining two female NPT fittings at this size and pressure rating will find it fits. Systems requiring a different length, a larger bore or a non-galvanised material should select another nipple.

Simple thread engagement

Apply pipe sealant or tape to the MNPT ends and tighten with a pipe wrench. The continuous weld and Schedule 40 wall thickness of 0.133 inch resist cracking, but cross-threading or over-tightening can damage threads and cause leaks.

Highlights

  • Reliable corrosion resistance from galvanized steel construction
  • Leak-tight joints with MNPT threads on both ends
  • Handles 150 psi at 150 °F for demanding systems
  • Schedule 40 wall thickness of .133 in adds strength
  • Meets ASTM A-53 Type F and ASTM A733 Grade A standards

Specifications

BrandBECK

Questions about this item

What thread size must the fittings I already have match for this 1 in MNPT nipple to connect?

Both ends are 1 in MNPT threads so any mating fitting must accept a 1 in male NPT connection.

Will the 0.133 in wall thickness of this Schedule 40 nipple mate cleanly with older Schedule 40 galvanized pipe I plan to keep?

Yes — it shares the same 1.315 in outside diameter and 0.133 in wall so threads engage uniformly with existing Schedule 40 components.

After threading it in how can I confirm the joint holds the rated 150 psi at 150 Degrees F?

Pressurise the system to working pressure and inspect every thread joint for leaks; a dry joint at test pressure shows the nipple is performing to its ASTM A53 Type F rating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.